Lines Matching +full:enable +full:- +full:charge +full:- +full:control
1 # SPDX-License-Identifier: GPL-2.0-only
5 Say Y here to enable power supply class support. This allows
15 Say Y here to enable debugging messages for power supply class
35 Say Y here to enable support APM status emulation using
42 Say Y here to enable support for the generic battery driver
57 Say Y here to enable support for the battery charger in the Maxim
64 Say Y here to enable support for the backup battery charger
71 Say Y here to enable support for the power management unit
78 Say Y here to enable support for the power management unit
90 Say Y here to enable battery monitor for Marvell 88PM860x chip.
97 Say Y here to enable support for the ADP5061 standalone battery
104 tristate "Active-semi ACT8945A charger driver"
107 Say Y here to enable support for power supply provided by
108 Active-semi ActivePath ACT8945A charger.
115 Say Y here to enable support for battery on Motorola
123 Say Y here to enable support for the cellwise cw2015
133 Say Y here to enable support for batteries with ds2760 chip.
141 Say Y here to enable support for batteries with ds2780 chip.
149 If you enable this you will have the DS2781 battery driver support.
158 tristate "DS2782/DS2786 standalone gas-gauge"
161 Say Y here to enable support for the DS2782/DS2786 standalone battery
162 gas-gauge.
168 Say Y here to enable support for the LEGO MINDSTORMS EV3 battery.
191 Say Y here to enable the Qualcomm PMIC GLINK power supply driver,
199 Say Y to enable support for the battery on the OLPC laptop.
204 Say Y to enable support for Samsung SDI battery data.
208 tristate "Sharp SL-5500 (collie) battery"
211 Say Y to enable support for the battery on the Sharp Zaurus
212 SL-5500 (collie) models.
223 called ingenic-battery.
236 Say Y to enable support for battery measured by WM97xx aux port.
242 Say Y to include support for SBS battery driver for SBS-compliant
264 called sbs-manager.
269 Say Y here to enable support for batteries with BQ27xxx chips.
277 Say Y here to enable support for batteries with BQ27xxx chips
286 Say Y here to enable support for batteries with BQ27xxx chips
293 Say Y here to enable devicetree monitored-battery config to update
294 NVM/flash data memory. Only enable this option for devices with a
297 general-purpose kernels, as this can cause misconfiguration of a
304 Say Y here to enable support for batteries charger integrated into
311 Say Y here to enable support for batteries charger integrated into
320 Say Y here to enable support for charger unit of the DA9150
321 Integrated Charger & Fuel-Gauge IC.
324 called da9150-charger.
330 Say Y here to enable support for the Fuel-Gauge unit of the DA9150
331 Integrated Charger & Fuel-Gauge IC
334 called da9150-fg.
337 tristate "X-Powers AXP20X and AXP22X AC power supply driver"
342 Say Y here to enable support for X-Powers AXP20X and AXP22X PMICs' AC
349 tristate "X-Powers AXP20X battery driver"
354 Say Y here to enable support for X-Powers AXP20X PMICs' battery power
369 tristate "X-Powers AXP288 Charger"
372 Say yes here to have support X-Power AXP288 power management IC (PMIC)
376 tristate "X-Powers AXP288 Fuel Gauge"
379 Say yes here to have support for X-Power power management IC (PMIC)
389 Driver supports Maxim fuel-gauge systems for lithium-ion (Li+)
394 Driver supports reporting SOC (State of Charge, i.e capacity),
395 voltage and configurable low-SOC wakeup interrupt.
404 MAX17042 is fuel-gauge systems for lithium-ion (Li+) batteries
407 multi-function devices that include fuel gauages that are compatible
419 MAX1720x is a family of fuel-gauge systems for lithium-ion (Li+)
427 tristate "MAX17211/MAX17215 standalone gas-gauge"
431 MAX1721x is fuel-gauge systems for lithium-ion (Li+) batteries
436 Say Y here to enable support for the MAX17211/MAX17215 standalone
437 battery gas-gauge.
443 Say Y here to enable this dumb driver for batteries managed
450 Say Y here to enable charger for Marvell 88PM860x chip.
459 tristate "Nokia RX-51 (N900) battery driver"
462 Say Y here to enable support for battery information on Nokia
463 RX-51, also known as N900 tablet.
471 Say Y to enable support for CPCAP PMIC charger driver for Motorola
479 Say Y to enable support for USB Charger Detection with
483 tristate "MAX8903 Battery DC-DC Charger for USB and Adapter Power"
485 Say Y to enable support for the MAX8903 DC-DC charger and sysfs.
486 The driver supports controlling charger-enable and current-limit
494 Say Y here to enable support for TWL4030 Battery Charge Interface.
500 Say Y here to enable support for LP8727 Charger Driver.
508 Say Y to enable support for the LP8788 linear charger.
518 called gpio-charger.
525 Say Y to enable charger-manager support, which allows multiple
527 system. The charger-manager also can monitor charging status in
528 runtime and in suspend-to-RAM by waking up the system periodically
539 tristate "LTC4162-L charger"
544 LTC4162-L battery charger connected to I2C.
550 Say Y to enable support for the battery charger control sysfs and
558 Say Y to enable support for the Maxim MAX14656 USB charger detector.
567 Say Y to enable support for the battery charger control of MAX77650
574 Say Y to enable support for the Maxim MAX77693 battery charger.
581 The Maxim MAX77976 is a 19 Vin, 5.5A 1-Cell Li+ Battery Charger
584 Say Y to enable support for the Maxim MAX77976 battery charger.
593 Say Y to enable support for the battery charger control sysfs and
600 Say Y to enable support for the battery charger control sysfs and
609 Select this option to enable support for Monolithic power system
619 Say Y here to enable MT6360 Charger Part.
620 The device supports High-Accuracy Voltage/Current Regulation,
622 Over-Temperature Protection, DPDM Detection for BC1.2.
631 Say Y here to enable MT6370 Charger Part.
632 The device supports High-Accuracy Voltage/Current Regulation,
634 Over-Temperature Protection, DPDM Detection for BC1.2.
637 will be called "mt6370-charger".
640 tristate "Qualcomm Switch-Mode Battery Charger and Boost"
646 Say Y to include support for the Switch-Mode Battery Charger and
648 is an integrated, single-cell lithium-ion battery charger. DT
654 tristate "Qualcomm PM8916 BMS-VM support"
680 Say Y to enable support for the TI BQ2415x battery charger
683 You'll need this driver to charge batteries on e.g. Nokia
684 RX-51/N900.
692 Say Y to enable support for the TI BQ24190 battery charger.
700 Say Y to enable support for the TI BQ24250, BQ24251, and BQ24257 battery
708 Say Y to enable support for the TI BQ24735 battery charger.
716 Say Y to enable support for the TI BQ2515X family of battery
718 battery charge management ICs that integrate the most common
720 rail, ADC for battery and system monitoring, and push-button
729 Say Y to enable support for the TI BQ25890 battery charger.
737 Say Y to enable support for the TI BQ25980, BQ25975 and BQ25960
746 Say Y to enable support for the TI BQ256XX battery chargers. The
747 BQ256XX family of devices are highly-integrated, switch-mode battery
748 charge management and system power path management devices for single
749 cell Li-ion and Li-polymer batteries.
770 Say Y here to enable support for battery charging with TPS65090
777 Say Y here to enable support for battery charging with TPS65217
785 Gauge IC. The driver reports the charge count continuously, and
800 Say Y to enable support for the Goldfish battery and AC power
810 The fuelgauge calculates and determines the battery state of charge
819 The device supports pre-charge mode, fast charge mode and
828 Say Y to enable support for Richtek RT9455 battery charger.
837 Say Y here to enable RT9467 Battery Charger.
838 RT9467 is a switch-mode single cell Li-Ion/Li-Polymer battery charger
840 power MOSFETs, input current sensing and regulation, high-accuracy
841 voltage regulation, and charge termination. The charge current is
843 USB On-The-Go (OTG) support and integrates D+/D- pin for USB
847 will be called "rt9467-charger".
857 highly-integrated switch mode battery charger which is system power
858 patch manageable device for single cell Li-Ion and Li-polymer battery.
869 Say Y here to enable ChromeOS EC based USBPD charger
879 Say Y here to enable ChromeOS EC based peripheral charge driver.
881 the peripheral charge ports from the EC and converts that into
885 tristate "ChromeOS EC based charge control"
890 Say Y here to enable ChromeOS EC based battery charge control.
891 This driver can manage charge thresholds and behaviour.
894 called cros_charge-control.
900 Say Y here to enable support for battery charging with SC2731
908 Say Y here to enable support for fuel gauge with SC27XX
918 Say Y to enable support for Microchip UCS1002 Programmable
926 Say Y here to enable support for getting battery and charger
934 Say Y here to enable control of the charging routines performed
937 Documentation/ABI/testing/sysfs-class-power-wilco
956 tristate "Battery driver for 7th-generation Microsoft Surface devices"
962 This driver provides battery-information and -status support for
964 devices. On those models (7th-generation), battery-information is
967 Say M or Y here to include battery status support for 7th-generation
972 tristate "AC driver for 7th-generation Microsoft Surface devices"
978 This driver provides AC-information and -status support for Surface
980 On those models (7th-generation), AC-information is instead handled
983 Say M or Y here to include AC status support for 7th-generation
993 Note the uG3105 is not a full-featured autonomous fuel-gauge. Instead
995 microcontroller reading its coulomb-counter before it can wrap
998 Since Linux does not monitor coulomb-counter changes while the
1007 Say Y here to enable the Qualcomm PMIC Charger driver. This
1016 Say Y here to enable the Mitsumi MM8013 fuel gauge driver.
1018 the state of charge, temperature, cycle count, actual and design