Lines Matching +full:firmware +full:- +full:gpio
2 # Copyright 2011-2020 NXP
9 # 51 Franklin Street, Fifth Floor, Boston, MA 02110-1301 USA or on the
10 # worldwide web at http://www.gnu.org/licenses/old-licenses/gpl-2.0.txt.
12 # THE FILE IS DISTRIBUTED AS-IS, WITHOUT WARRANTY OF ANY KIND, AND THE
23 a) Copy sd8787.bin to /lib/firmware/mrvl/ directory,
38 Following are some useful iw commands:-
45 iw dev mlan0 connect -w <SSID> [<freq in MHz>] [<bssid>] [key 0:abcde d:1123456789a]
55 iw dev mlan0 ibss join <SSID> <freq in MHz> [fixed-freq] [fixed-bssid] [key 0:abcde]
79 mount -t debugfs debugfs /debugfs
98 bss_mode = "Ad-hoc" | "Managed" | "Auto" | "Unknown"
100 mac_address = <6-byte adapter MAC address>
128 ps_state = <0/1/2/3, full power state/awake state/pre-sleep state/sleep state>
156 mp_rd_bitmap = <SDIO multi-port read bitmap>
157 mp_wr_bitmap = <SDIO multi-port write bitmap>
186 This command is used to read/write the firmware memory.
189 1) For reading firmware memory location.
192 2) For writing value to firmware memory location.
203 iwpriv mlan0 memrdwr -0x7fff6000 -0x40000000
216 <length>: 4-20, multiples of 4
226 echo "<condition> [GPIO# [gap]]]" > hscfg
230 <condition>: bit 0 = 1 -- broadcast data
231 bit 1 = 1 -- unicast data
232 bit 2 = 1 -- mac event
233 bit 3 = 1 -- multicast data
234 [GPIO#]: pin number of GPIO used to wakeup the host.
235 GPIO pin# (e.g. 0-7) or 0xff (interface, e.g. SDIO
239 acknowledge required) when GPIO is used to wakeup host.
242 echo "-1" > hscfg : Cancel host sleep mode
244 Use GPIO and gap set previously
245 echo "2 3" > hscfg : Unicast data and GPIO 3;
247 echo "2 1 160" > hscfg : Unicast data, GPIO 1 and gap 160 ms
248 echo "2 1 0xff" > hscfg : Unicast data, GPIO 1; Wait for host
258 This command is used to dump driver information and firmware memory
265 This command is used to get extended firmware version string using
272 [version_str_sel]: firmware support several extend version