Lines Matching full:factory

242  * temperature with factory-measured temperatures when calculating txpower
278  * 2)  Factory txpower calibration information is provided separately for
336  *     factory measurement for ht40 channels.
348  * 4)  Linearly interpolate (EEPROM) factory calibration measurement sets,
349  *     referencing the 2 factory-measured (sample) channels within the sub band.
375  *     Driver should interpolate factory values for temperature, gain table
385  *     factory-measured txpower.  Using (interpolated) factory gain table idx
390  *     For example, if factory measured txpower is 16 dBm, and target txpower
391  *     is 13 dBm, add 6 steps to the factory gain idx to reduce txpower
396  *     factory-measured temperature for sub-band.  Factory values are in
400  *     If current temperature is higher than factory temperature, driver must
416  *     (from "initialize alive") and factory-measured power supply voltage
419  *     If the current voltage is higher (indicator is lower) than factory
424  *     If the current voltage is lower (indicator is higher) than factory
529  * EEPROM contains factory calibration data for txpower.  This maps actual
531  * below ("well-known" means here that both factory calibration *and* the
537  * present during factory calibration).  A 5 Ghz EEPROM idx of "40"
807  * factory calibration temperature in EEPROM; if current temperature is higher
808  * than factory temperature, driver must *increase* gain by proportions shown
809  * in table below.  If current temperature is lower than factory, driver must