Lines Matching full:indicates
54 * Indicates the first MSDU of the PPDU. If both first_mpdu
62 * Indicates the last MSDU of the last MPDU of the PPDU. The
72 * Indicates no matching entries within the max search
76 * Indicates an unsuccessful search for the peer index due to
88 * Set if frame type indicates either null data or QoS null
112 * Indicates that this is an 802.11 fragment frame. This is
122 * Indicates that this status has a corresponding MSDU that
135 * Indicates that the MSDU length from the 802.3 encapsulated
139 * Indicates that the computed checksum (tcp_udp_chksum) did
143 * Indicates that the computed checksum did not match the
147 * Indicates no matching entry was found in the address search
151 * Indicates no matching entry was found in the address search
155 * Indicates an unsuccessful search for the source MAC address
159 * Indicates an unsuccessful search for the destination MAC
163 * Indicates that this data type frame is not encrypted even if
174 * Indicates that at least one of the rx buffers has been
179 * Indicates that the MPDU was pre-maturely terminated
184 * Indicates that the MPDU Michael integrity check failed
187 * Indicates that the MPDU decrypt integrity check failed
190 * Indicates that the MPDU FCS check failed
193 * If set indicates that the RX packet data, RX header data, RX
227 * Indicates the number of more buffers associated with RX DMA
231 * Indicates the number of more buffers associated with RX DMA
235 * Indicates the number of more buffers associated with RX DMA
239 * Indicates the number of more buffers associated with RX DMA
317 * Indicates type of decrypt cipher used (as defined in the
390 * Indicates that this is the last MPDU of a PPDU.
393 * Indicates that a delimiter FCS error occurred after this
510 * Indicates the IP offset in bytes from the start of the
515 * Indicates the destination RX rings for this MSDU.
518 * Indicates the offset in bytes to the start of TCP or UDP
521 * indicates that the offset is longer than 127 bytes.
539 * Indicates the MSDU number within a MPDU. This value is
544 * Indicates the format after decapsulation:
551 * Set if L2 layer indicates IPv4 protocol.
554 * Set if L2 layer indicates IPv6 protocol.
558 * protocol indicates TCP.
562 * protocol indicates UDP.
565 * Indicates that either the IP More frag bit is set or IP frag
566 * number is non-zero. If set indicates that this is a
662 * Indicates the number classification filter rule
687 * Indicates the first MSDU of A-MSDU. If both first_msdu and
693 * Indicates the last MSDU of the A-MSDU. MPDU end status is
697 * Indicates that the MSDU threshold was exceeded and thus
706 * Indicates that the first delimiter had a FCS failure. Only
768 * Value of 0x80 indicates invalid.
772 * Value of 0x80 indicates invalid.
776 * Value of 0x80 indicates invalid.
780 * Value of 0x80 indicates invalid.
784 * Value of 0x80 indicates invalid.
788 * Value of 0x80 indicates invalid.
792 * Value of 0x80 indicates invalid.
796 * Value of 0x80 indicates invalid.
800 * Value of 0x80 indicates invalid.
804 * Value of 0x80 indicates invalid.
808 * Value of 0x80 indicates invalid.
812 * Value of 0x80 indicates invalid.
816 * Value of 0x80 indicates invalid.
820 * Value of 0x80 indicates invalid.
824 * Value of 0x80 indicates invalid.
828 * Value of 0x80 indicates invalid.
832 * bandwidths. Value of 0x80 indicates invalid.
863 * Legacy signal rate select. If set then l_sig_rate indicates
864 * CCK rates. If clear then l_sig_rate indicates OFDM rates.
876 * Indicates the type of preamble ahead:
905 * Indicates that the packet data carries H information which
1254 * Indicates a PHY error was detected for this PPDU.
1257 * Indicates that location information was requested.
1260 * Indicates that the packet data carries H information which
1270 * Indicates that a HT or VHT Ack/BA frame was transmitted in
1274 * Indicates that the BB has captured a channel dump. FW can
1284 * Indicates the number of bytes of baseband information for
1286 * which indicates that this is not a normal PPDU but rather