260 		e_err(probe, "Unable to allocate interrupt Error: %d\n", err);  in e1000_request_irq()
874 		e_err(probe, "Unknown MAC Type\n");  in e1000_init_hw_struct()
1075 		e_err(probe, "EEPROM initialization failed\n");  in e1000_probe()
1087 		e_err(probe, "The EEPROM Checksum Is Not Valid\n");  in e1000_probe()
1100 			e_err(probe, "EEPROM Read Error\n");  in e1000_probe()
1106 		e_err(probe, "Invalid MAC Address\n");  in e1000_probe()
1301 		e_err(probe, "Unable to allocate memory for queues\n");  in e1000_sw_init()
1523 		e_err(tx_err, "txdr align check failed: %u bytes at %p\n",  in e1000_setup_tx_resources()
1541 			e_err(probe, "Unable to allocate aligned memory "  in e1000_setup_tx_resources()
1573 			e_err(probe, "Allocation for Tx Queue %u failed\n", i);  in e1000_setup_all_tx_resources()
1715 		e_err(rx_err, "rxdr align check failed: %u bytes at %p\n",  in e1000_setup_rx_resources()
1733 			e_err(probe, "Unable to allocate aligned memory for "  in e1000_setup_rx_resources()
1765 			e_err(probe, "Allocation for Rx Queue %u failed\n", i);  in e1000_setup_all_rx_resources()
3157 					e_err(drv, "__pskb_pull_tail "  in e1000_xmit_frame()
3506 	e_err(drv, "Reset adapter\n");  in e1000_reset_task()
3527 			e_err(probe, "Jumbo Frames not supported.\n");  in e1000_change_mtu()
3902 			e_err(drv, "Detected Tx Unit Hang\n"  in e1000_clean_tx_irq()
4587 			e_err(rx_err, "skb align check failed: %u bytes at "  in e1000_alloc_rx_buffers()
4628 			e_err(rx_err, "dma align check failed: %u bytes at "  in e1000_alloc_rx_buffers()
4846 		e_err(probe, "Error in setting MWI\n");  in e1000_pci_set_mwi()
5051 	e_err(probe, "Unsupported Speed/Duplex configuration\n");  in e1000_set_spd_dplx()