Lines Matching +full:stmpe +full:- +full:gpio
1 # SPDX-License-Identifier: GPL-2.0-only
21 necessary for using the board's GPIO and MFGPT functionality.
30 Say yes here to add support for the Analog Devices ADP5585 GPIO
33 the GPIO and PWM functions under the corresponding menus.
43 accessing the external gpio extender (LEDs & buttons) and
57 tristate "Active-semi ACT8945A"
62 Support for the ACT8945A PMIC from Active-semi. This device
63 features three step-down DC/DC converters and four low-dropout
79 sun4i-gpadc-iio and the hwmon driver iio_hwmon.
82 called sun4i-gpadc.
113 tablets etc. It has 4 DC/DC step-down regulators, 3 DC/DC step-down
144 over at91-usart-serial driver and usart-spi-driver. Only one function
160 tristate "Atmel HLCDC (High-end LCD Controller)"
190 voltage regulator, voltage sampling units, GPIO block and
197 tristate "X-Powers AC100"
201 If you say Y here you get support for the X-Powers AC100 audio codec
212 tristate "X-Powers AXP series PMICs with I2C"
217 If you say Y here you get support for the X-Powers AXP series power
229 tristate "X-Powers AXP series PMICs with RSB"
233 If you say Y here you get support for the X-Powers AXP series power
246 sub-devices. This driver will instantiate additional drivers such
250 called cros-ec-dev.
356 usually found on PXA processors-based platforms. This includes
359 LEDs and battery-charger under the corresponding menus.
428 tristate "Dialog Semiconductor DA9150 Charger Fuel-Gauge chip"
434 This adds support for the DA9150 integrated charger and fuel-gauge
444 This adds support for Diolan USB-I2C/SPI/GPIO Master Adapter
445 DLN-2. Additional drivers such as I2C_DLN2, GPIO_DLN2,
455 This adds support for the power-off functionality and access to
480 such as push-button monitor, multiple ADC's for voltage and
530 Analog-to-Digital Converter (LRADC) found on the i.MX23 and i.MX28
534 mxs-lradc-adc for ADC readings
535 mxs-lradc-ts for touchscreen support
538 called mxs-lradc.
555 Add support for HiSilicon Hi6421 PMIC. Hi6421 includes multi-
560 We communicate with the Hi6421 via memory-mapped I/O.
570 multi-functions, such as regulators, RTC, codec, Coulomb counter,
589 tristate "Intel Quark MFD I2C GPIO"
595 This MFD provides support for I2C and GPIO that exist only
598 The GPIO exports a total amount of 8 interrupt-capable GPIOs.
608 other drivers to control these functions, currently GPIO and
629 on some Intel SoC systems. The PMIC provides ADC, GPIO,
635 causes the designware-i2c driver to be builtin for the same reason.
644 on Intel Broxton systems. The PMIC provides ADC, GPIO,
662 causes the designware-i2c driver to be builtin for the same reason.
679 needs the designware-i2c driver to be builtin for the same reason.
703 I2C, SPI and HS-UART starting from Intel Sunrisepoint (Intel Skylake
712 I2C, SPI and HS-UART starting from Intel Sunrisepoint (Intel Skylake
725 multi-function device that exposes IPC, General Control
726 Register and P-unit access. In addition this creates devices
746 IQS621, IQS622, IQS624 and IQS625 multi-function sensors. Additional
747 options must be selected to enable device-specific functions.
753 tristate "Janz CMOD-IO PCI MODULbus Carrier Board"
757 This is the core driver for the Janz CMOD-IO PCI MODULbus
760 CAN and GPIO controllers.
769 functions like watchdog, GPIO, UART and I2C bus.
772 will be called kempld-core.
784 battery-charger under the corresponding menus.
807 battery-charger under the corresponding menus.
830 MAX77836 Micro-USB ICs with battery charger.
875 the following functionalities of the device: GPIO, regulator,
916 low-dropout regulators, 8 GPIOs, RTC, watchdog etc. This driver
992 PMIC part includes 2-channel BUCKs and 2-channel LDOs
993 LDO part includes 4-channel LDOs
1005 voltage supply, one general purpose LDO, and the USB Type-C & PD
1006 controller complies with the latest USB Type-C and PD standards.
1028 The device supports multiple sub-devices like LED, HWMON and WDT.
1053 called ocelot-soc.
1098 certain e-book readers designed by the original design manufacturer
1102 tristate "Nokia Retu and Tahvo multi-function device"
1107 Retu and Tahvo are a multi-function devices found on Nokia
1118 so that function-specific drivers can bind to them.
1128 tristate "NXP PCF50633 GPIO"
1131 Say yes here if you want to include support GPIO for pins on
1142 built-in PM8xxx PMIC chips.
1148 module. This will build a module called "pm8xxx-core".
1177 series as a module. The module will be called "qcom-spmi-pmic".
1186 To enable support for building sub-devices as modules,
1190 tristate "RDC R-321x southbridge"
1194 Say yes here if you want to have support for the RDC R-321x SoC
1218 sub-devices like charger, fuel gauge, flash LED, current source,
1242 through i2c interface. The device supports multiple sub-devices
1243 like GPIO, interrupts, RTC, LDO and DCDC regulators, onkey.
1262 through I2C interface. The device supports multiple sub-devices
1276 through an SPI interface. The device supports multiple sub-devices
1277 including interrupts, LDO & DCDC regulators, and power on-key.
1308 module will be called sec-core.
1320 radio. This MFD driver connects the radio-si476x V4L2 module
1324 module will be called si476x-core.
1333 to be shared by all sub-devices.
1336 sub-devices represented by child nodes in Device Tree will be
1349 * SMARC-sAL28
1363 bool "Export GPIO via GPIO layer"
1366 This option uses the gpio library layer to export the 64 GPIO
1368 base number for the first GPIO line to register.
1404 the Multi-Function Timer Pulse Unit 3 (MTU3a) hardware available
1410 bool "ST-Ericsson ABX500 Mixed Signal Circuit register functions"
1421 bool "ST-Ericsson AB8500 Mixed Signal Power Management chip"
1434 bool "ST-Ericsson DB8500 Power Reset Control Management Unit"
1444 bool "STMicroelectronics STMPE"
1449 Support for the STMPE family of I/O Expanders from
1454 STMPE811: GPIO, Touchscreen, ADC
1455 STMPE1601: GPIO, Keypad
1456 STMPE1801: GPIO, Keypad
1457 STMPE2401: GPIO, Keypad
1458 STMPE2403: GPIO, Keypad
1464 GPIO: stmpe-gpio
1465 Keypad: stmpe-keypad
1466 Touchscreen: stmpe-ts
1467 ADC: stmpe-adc
1469 menu "STMicroelectronics STMPE Interface Drivers"
1473 bool "STMicroelectronics STMPE I2C Interface"
1477 This is used to enable I2C interface of STMPE
1480 bool "STMicroelectronics STMPE SPI Interface"
1483 This is used to enable SPI interface of STMPE
1527 This driver consists of GPIO and PWM drivers.
1529 general usage such like a GPIO controller and a PWM controller.
1581 high-power "white LED driver". This boost converter is
1583 also contains a GPIO pin.
1693 These include voltage regulators, gpio and other features
1781 will be called tps6594-i2c.
1794 will be called tps6594-spi.
1806 so that function-specific drivers can bind to them.
1808 These multi-function chips are found on many OMAP2 and OMAP3
1809 boards, providing power management, RTC, GPIO, keypad, a
1822 This driver uses board-specific data to initialize the resources
1852 regulators, Dual slot memory card transceivers, real-time clock
1863 driver connects the radio-wl1273 V4L2 module and the wl1273
1877 backlight or ambient-light-sensor functionality of the device.
1888 for in-vehicle infontainment, called Russellville.
1903 tristate "TQ-Systems IO controller TQMX86"
1907 TQ-Systems IO controller and watchdog device, found on their
2044 The WM8994 is a highly integrated hi-fi CODEC designed for
2046 has on board GPIO and regulator functionality which is
2058 The WM9705, WM9712 and WM9713 is a highly integrated hi-fi CODEC
2060 it has on board GPIO and a touchscreen functionality which is
2072 in various ST Microelectronics and ST-Ericsson embedded
2097 Power Management ICs. BD71828GW and BD71815AGW are single-chip power
2098 management ICs mainly for battery-powered portable devices.
2101 also a single-cell linear charger, a Coulomb counter, a real-time
2114 designed to be used to power R-Car series processors.
2130 tristate "Support for STM32 Low-Power Timer"
2136 Select this option to enable STM32 Low-Power Timer driver
2141 module will be called stm32-lptimer.
2171 tristate "Support for STMicroelectronics Multi-Function eXpander (STMFX)"
2177 Support for the STMicroelectronics Multi-Function eXpander.
2227 power-on options, power-off control and system FAN control on recent
2300 called "cs40l50-i2c".
2312 called "cs40l50-spi".
2338 This option enables basic support for the SGI IOC3-based