Lines Matching +full:db8500 +full:- +full:prcmu +full:- +full:regulators
1 # SPDX-License-Identifier: GPL-2.0-only
57 tristate "Active-semi ACT8945A"
62 Support for the ACT8945A PMIC from Active-semi. This device
63 features three step-down DC/DC converters and four low-dropout
64 linear regulators, along with a complete ActivePath battery
79 sun4i-gpadc-iio and the hwmon driver iio_hwmon.
82 called sun4i-gpadc.
113 tablets etc. It has 4 DC/DC step-down regulators, 3 DC/DC step-down
144 over at91-usart-serial driver and usart-spi-driver. Only one function
160 tristate "Atmel HLCDC (High-end LCD Controller)"
197 tristate "X-Powers AC100"
201 If you say Y here you get support for the X-Powers AC100 audio codec
212 tristate "X-Powers AXP series PMICs with I2C"
217 If you say Y here you get support for the X-Powers AXP series power
220 components like regulators or the PEK (Power Enable Key) under the
229 tristate "X-Powers AXP series PMICs with RSB"
233 If you say Y here you get support for the X-Powers AXP series power
236 components like regulators or the PEK (Power Enable Key) under the
246 sub-devices. This driver will instantiate additional drivers such
250 called cros-ec-dev.
356 usually found on PXA processors-based platforms. This includes
358 individual components like LCD backlight, voltage regulators,
359 LEDs and battery-charger under the corresponding menus.
428 tristate "Dialog Semiconductor DA9150 Charger Fuel-Gauge chip"
434 This adds support for the DA9150 integrated charger and fuel-gauge
444 This adds support for Diolan USB-I2C/SPI/GPIO Master Adapter
445 DLN-2. Additional drivers such as I2C_DLN2, GPIO_DLN2,
455 This adds support for the power-off functionality and access to
480 such as push-button monitor, multiple ADC's for voltage and
530 Analog-to-Digital Converter (LRADC) found on the i.MX23 and i.MX28
534 mxs-lradc-adc for ADC readings
535 mxs-lradc-ts for touchscreen support
538 called mxs-lradc.
555 Add support for HiSilicon Hi6421 PMIC. Hi6421 includes multi-
556 functions, such as regulators, RTC, codec, Coulomb counter, etc.
558 individual components like voltage regulators under corresponding
560 We communicate with the Hi6421 via memory-mapped I/O.
570 multi-functions, such as regulators, RTC, codec, Coulomb counter,
574 individual components like voltage regulators under corresponding
598 The GPIO exports a total amount of 8 interrupt-capable GPIOs.
635 causes the designware-i2c driver to be builtin for the same reason.
662 causes the designware-i2c driver to be builtin for the same reason.
679 needs the designware-i2c driver to be builtin for the same reason.
703 I2C, SPI and HS-UART starting from Intel Sunrisepoint (Intel Skylake
712 I2C, SPI and HS-UART starting from Intel Sunrisepoint (Intel Skylake
725 multi-function device that exposes IPC, General Control
726 Register and P-unit access. In addition this creates devices
746 IQS621, IQS622, IQS624 and IQS625 multi-function sensors. Additional
747 options must be selected to enable device-specific functions.
753 tristate "Janz CMOD-IO PCI MODULbus Carrier Board"
757 This is the core driver for the Janz CMOD-IO PCI MODULbus
772 will be called kempld-core.
783 select individual components like voltage regulators, RTC and
784 battery-charger under the corresponding menus.
806 select individual components like voltage regulators, RTC and
807 battery-charger under the corresponding menus.
830 MAX77836 Micro-USB ICs with battery charger.
846 There are regulators and adc.
859 RTC, regulators, clock generator, watchdog etc. This driver
915 This is a Power Management IC with 4 buck regulators, 9
916 low-dropout regulators, 8 GPIOs, RTC, watchdog etc. This driver
992 PMIC part includes 2-channel BUCKs and 2-channel LDOs
993 LDO part includes 4-channel LDOs
1005 voltage supply, one general purpose LDO, and the USB Type-C & PD
1006 controller complies with the latest USB Type-C and PD standards.
1028 The device supports multiple sub-devices like LED, HWMON and WDT.
1053 called ocelot-soc.
1098 certain e-book readers designed by the original design manufacturer
1102 tristate "Nokia Retu and Tahvo multi-function device"
1107 Retu and Tahvo are a multi-function devices found on Nokia
1118 so that function-specific drivers can bind to them.
1142 built-in PM8xxx PMIC chips.
1145 such as: MPPs, GPIOs, regulators, interrupts, and PWM.
1148 module. This will build a module called "pm8xxx-core".
1158 This is required to access many regulators, clocks and bus
1177 series as a module. The module will be called "qcom-spmi-pmic".
1186 To enable support for building sub-devices as modules,
1190 tristate "RDC R-321x southbridge"
1194 Say yes here if you want to have support for the RDC R-321x SoC
1218 sub-devices like charger, fuel gauge, flash LED, current source,
1242 through i2c interface. The device supports multiple sub-devices
1243 like GPIO, interrupts, RTC, LDO and DCDC regulators, onkey.
1262 through I2C interface. The device supports multiple sub-devices
1263 including interrupts, RTC, LDO & DCDC regulators, and onkey.
1276 through an SPI interface. The device supports multiple sub-devices
1277 including interrupts, LDO & DCDC regulators, and power on-key.
1308 module will be called sec-core.
1309 Have in mind that important core drivers (like regulators) depend
1320 radio. This MFD driver connects the radio-si476x V4L2 module
1324 module will be called si476x-core.
1333 to be shared by all sub-devices.
1336 sub-devices represented by child nodes in Device Tree will be
1349 * SMARC-sAL28
1404 the Multi-Function Timer Pulse Unit 3 (MTU3a) hardware available
1410 bool "ST-Ericsson ABX500 Mixed Signal Circuit register functions"
1421 bool "ST-Ericsson AB8500 Mixed Signal Power Management chip"
1429 since hardware version v1.0) or the I2C bus via PRCMU. It also adds
1434 bool "ST-Ericsson DB8500 Power Reset Control Management Unit"
1438 Select this option to enable support for the DB8500 Power Reset
1464 GPIO: stmpe-gpio
1465 Keypad: stmpe-keypad
1466 Touchscreen: stmpe-ts
1467 ADC: stmpe-adc
1538 TI LP8788 PMU supports regulators, battery charger, RTC,
1581 high-power "white LED driver". This boost converter is
1591 Power Management chips. These include voltage regulators,
1605 regulators, lithium ion/polymer battery charging, touch screen
1649 These include voltage regulators, lithium ion/polymer battery
1664 These include voltage regulators, thermal protection, configurable
1678 These include voltage regulators, thermal protection, configurable
1693 These include voltage regulators, gpio and other features
1707 Management ICs. These include voltage regulators, GPIOs and
1781 will be called tps6594-i2c.
1794 will be called tps6594-spi.
1806 so that function-specific drivers can bind to them.
1808 These multi-function chips are found on many OMAP2 and OMAP3
1818 TWL4030 family chips. Most of these resources are regulators,
1822 This driver uses board-specific data to initialize the resources
1852 regulators, Dual slot memory card transceivers, real-time clock
1863 driver connects the radio-wl1273 V4L2 module and the wl1273
1877 backlight or ambient-light-sensor functionality of the device.
1888 for in-vehicle infontainment, called Russellville.
1903 tristate "TQ-Systems IO controller TQMX86"
1907 TQ-Systems IO controller and watchdog device, found on their
2044 The WM8994 is a highly integrated hi-fi CODEC designed for
2058 The WM9705, WM9712 and WM9713 is a highly integrated hi-fi CODEC
2072 in various ST Microelectronics and ST-Ericsson embedded
2097 Power Management ICs. BD71828GW and BD71815AGW are single-chip power
2098 management ICs mainly for battery-powered portable devices.
2101 also a single-cell linear charger, a Coulomb counter, a real-time
2114 designed to be used to power R-Car series processors.
2130 tristate "Support for STM32 Low-Power Timer"
2136 Select this option to enable STM32 Low-Power Timer driver
2141 module will be called stm32-lptimer.
2171 tristate "Support for STMicroelectronics Multi-Function eXpander (STMFX)"
2177 Support for the STMicroelectronics Multi-Function eXpander.
2227 power-on options, power-off control and system FAN control on recent
2300 called "cs40l50-i2c".
2312 called "cs40l50-spi".
2338 This option enables basic support for the SGI IOC3-based