88 		dev_err(panel->dev, "failed to set display off: %d\n", ret);  in jdi_panel_unprepare()
92 		dev_err(panel->dev, "failed to set display off: %d\n", ret);  in jdi_panel_unprepare()
99 		dev_err(panel->dev, "failed to enter sleep mode: %d\n", ret);  in jdi_panel_unprepare()
102 		dev_err(panel->dev, "failed to enter sleep mode: %d\n", ret);  in jdi_panel_unprepare()
137 		dev_err(&left->dev, "failed to set column address: %d\n", err);  in jdi_setup_symmetrical_split()
143 		dev_err(&right->dev, "failed to set column address: %d\n", err);  in jdi_setup_symmetrical_split()
149 		dev_err(&left->dev, "failed to set page address: %d\n", err);  in jdi_setup_symmetrical_split()
155 		dev_err(&right->dev, "failed to set page address: %d\n", err);  in jdi_setup_symmetrical_split()
205 		dev_err(panel->dev, "failed to enable supply: %d\n", err);  in jdi_panel_prepare()
213 		dev_err(panel->dev, "failed to enable ddi_supply: %d\n", err);  in jdi_panel_prepare()
237 		dev_err(panel->dev, "failed to set up symmetrical split: %d\n",  in jdi_panel_prepare()
245 		dev_err(panel->dev, "failed to set tear scanline: %d\n", err);  in jdi_panel_prepare()
252 		dev_err(panel->dev, "failed to set tear scanline: %d\n", err);  in jdi_panel_prepare()
259 		dev_err(panel->dev, "failed to set tear on: %d\n", err);  in jdi_panel_prepare()
266 		dev_err(panel->dev, "failed to set tear on: %d\n", err);  in jdi_panel_prepare()
272 		dev_err(panel->dev, "failed to set pixel format: %d\n", err);  in jdi_panel_prepare()
278 		dev_err(panel->dev, "failed to set pixel format: %d\n", err);  in jdi_panel_prepare()
284 		dev_err(panel->dev, "failed to exit sleep mode: %d\n", err);  in jdi_panel_prepare()
290 		dev_err(panel->dev, "failed to exit sleep mode: %d\n", err);  in jdi_panel_prepare()
296 		dev_err(panel->dev, "failed to write dcdc registers: %d\n", err);  in jdi_panel_prepare()
307 		dev_err(panel->dev, "failed to set display on: %d\n", err);  in jdi_panel_prepare()
313 		dev_err(panel->dev, "failed to set display on: %d\n", err);  in jdi_panel_prepare()
372 		dev_err(dev, "failed to add mode %ux%ux@%u\n",  in jdi_panel_get_modes()
412 				     "failed to get power regulator\n");  in jdi_panel_add()
417 				     "failed to get ddi regulator\n");  in jdi_panel_add()
422 				     "failed to get reset gpio\n");  in jdi_panel_add()
429 				     "failed to get enable gpio\n");  in jdi_panel_add()
436 				     "failed to create backlight\n");  in jdi_panel_add()
518 		dev_err(&dsi->dev, "failed to disable panel: %d\n", err);  in jdi_panel_dsi_remove()
522 		dev_err(&dsi->dev, "failed to detach from DSI host: %d\n", err);  in jdi_panel_dsi_remove()