mach-se/7724/setup.c

1 // SPDX-License-Identifier: GPL-2.0
35 #include <linux/dma-map-ops.h>
37 #include <mach-se/mach/se7724.h>
38 #include <media/drv-intf/renesas-ceu.h>
51  * ------------------------------------
55  * SW41 : abxx xxxx  -> a = 0 : Analog  monitor
73  * Please change J20, J21, J22 pin to 1-2 connection.
85 	.id             = -1,
123 		.mask_flags = MTD_WRITEABLE,	/* Read-only */
129 		.name = "free-area",
151 	.name		= "physmap-flash",
196 		.panel_cfg = { /* 7.0 inch */
244 	.name		= "renesas-ceu",
272 	.name		= "renesas-ceu",
282 /* change J20, J21, J22 pin to 1-2 connection to use slave mode */
305 	.card		= "FSIA-AK4642",
306 	.codec		= "ak4642-codec.0-0012",
310 		.name	= "fsia-dai",
313 		.name	= "ak4642-hifi",
319 	.name	= "asoc-simple-card",
325 /* KEYSC in SoC (Needs SW33-2 set to ON) */
367 		.end   = SH_ETH_ADDR + 0x1FC - 1,
382 	.name = "sh7724-ether",
398 		.end	= 0xa4d80124 - 1,
537 #include <media/drv-intf/sh_vou.h>
569 	.name           = "sh-vou",
570 	.id		= -1,
617 	while (t--) {  in sh_eth_is_eeprom_ready()
646 		sh_eth_plat.mac_addr[(i << 1) + 1] = mac >> 8;  in sh_eth_init()
684 	/* register board specific self-refresh code */  in devices_setup()
692 	regulator_register_always_on(0, "fixed-3.3V", fixed3v3_power_consumers,  in devices_setup()
703 		      (1 << 8)  | /* IrDA */  in devices_setup()
884 	 * enable SH-Eth  in devices_setup()
940 	device_initialize(&ms7724se_ceu_devices[0]->dev);  in devices_setup()
941 	dma_declare_coherent_memory(&ms7724se_ceu_devices[0]->dev,  in devices_setup()
946 	device_initialize(&ms7724se_ceu_devices[1]->dev);  in devices_setup()
947 	dma_declare_coherent_memory(&ms7724se_ceu_devices[1]->dev,  in devices_setup()