Lines Matching +full:smp +full:- +full:offset
1 # SPDX-License-Identifier: GPL-2.0
81 <http://www.linux-sh.org/>.
95 depends on SMP && PREEMPTION
214 prompt "Processor sub-type selection"
220 # SH-2 Processor Support
231 select GENERIC_CLOCKEVENTS_BROADCAST if SMP
233 # SH-2A Processor Support
279 bool "Support MX-G processor"
283 Select MX-G if running on an R8A03022BG part.
285 # SH-3 Processor Support
295 Select SH7706 if you have a 133 Mhz SH-3 HD6417706 CPU.
301 Select SH7707 if you have a 60 Mhz SH-3 HD6417707 CPU.
307 Select SH7708 if you have a 60 Mhz SH-3 HD6417708S or
308 if you have a 100 Mhz SH-3 HD6417708R CPU.
314 Select SH7709 if you have a 80 Mhz SH-3 HD6417709 CPU.
321 Select SH7710 if you have a SH3-DSP SH7710 CPU.
328 Select SH7712 if you have a SH3-DSP SH7712 CPU.
338 Select SH7720 if you have a SH3-DSP SH7720 CPU.
347 Select SH7721 if you have a SH3-DSP SH7721 CPU.
349 # SH-4 Processor Support
355 Select SH7750 if you have a 200 Mhz SH-4 HD6417750 CPU.
361 Select SH7091 if you have an SH-4 based Sega device (such as
376 Select SH7751 if you have a 166 Mhz SH-4 HD6417751 CPU,
387 # SH-4A Processor Support
398 Select SH7723 if you have an SH-MobileR2 CPU.
409 Select SH7724 if you have an SH-MobileR2R CPU.
455 select GENERIC_CLOCKEVENTS_BROADCAST if SMP
461 bool "Support SH-X3 processor"
464 select GENERIC_CLOCKEVENTS_BROADCAST if SMP
468 # SH4AL-DSP Processor Support
568 than the panic-ed kernel.
570 config SMP config
571 bool "Symmetric multi-processing support"
578 If you say N here, the kernel will run on uni- and multiprocessor
587 See also <file:Documentation/admin-guide/lockup-watchdogs.rst> and the SMP-HOWTO
593 int "Maximum number of CPUs (2-32)"
595 depends on SMP
603 This is purely to save memory - each supported CPU adds
607 bool "Support for hot-pluggable CPUs (EXPERIMENTAL)"
608 depends on SMP
615 depends on !SMP
618 This is the default implementation for both UP and non-ll/sc
628 bool "Implement atomic operations by roll-back (gRB) (EXPERIMENTAL)"
632 atomic operations using a software implementation of load-locked/
633 store-conditional (LLSC). On machines which do not have hardware
679 This sets the default offset of zero page.
690 This option allows you to set the link address offset of the zImage.
735 Uses the command-line options passed by the boot loader.