Lines Matching +full:otg +full:- +full:rev
1 // SPDX-License-Identifier: GPL-2.0
3 * Device Tree Source for the HiHope RZ/G2H Rev.4.0 and
4 * HiHope RZ/G2[MN] Rev.[2.0/3.0/4.0] main board common parts
9 #include <dt-bindings/gpio/gpio.h>
30 stdout-path = "serial0:115200n8";
33 hdmi0-out {
34 compatible = "hdmi-connector";
39 remote-endpoint = <&rcar_dw_hdmi0_out>;
45 compatible = "gpio-leds";
64 reg_1p8v: regulator-1p8v {
65 compatible = "regulator-fixed";
66 regulator-name = "fixed-1.8V";
67 regulator-min-microvolt = <1800000>;
68 regulator-max-microvolt = <1800000>;
69 regulator-boot-on;
70 regulator-always-on;
73 reg_3p3v: regulator-3p3v {
74 compatible = "regulator-fixed";
75 regulator-name = "fixed-3.3V";
76 regulator-min-microvolt = <3300000>;
77 regulator-max-microvolt = <3300000>;
78 regulator-boot-on;
79 regulator-always-on;
83 compatible = "audio-graph-card";
85 label = "rcar-sound";
90 vbus0_usb2: regulator-vbus0-usb2 {
91 compatible = "regulator-fixed";
93 regulator-name = "USB20_VBUS0";
94 regulator-min-microvolt = <5000000>;
95 regulator-max-microvolt = <5000000>;
98 enable-active-high;
101 vccq_sdhi0: regulator-vccq-sdhi0 {
102 compatible = "regulator-gpio";
104 regulator-name = "SDHI0 VccQ";
105 regulator-min-microvolt = <1800000>;
106 regulator-max-microvolt = <3300000>;
109 gpios-states = <1>;
113 x302_clk: x302-clock {
114 compatible = "fixed-clock";
115 #clock-cells = <0>;
116 clock-frequency = <33000000>;
119 x304_clk: x304-clock {
120 compatible = "fixed-clock";
121 #clock-cells = <0>;
122 clock-frequency = <25000000>;
127 clock-frequency = <22579200>;
143 clock-frequency = <16666666>;
147 clock-frequency = <32768>;
151 usb1-reset-hog {
152 gpio-hog;
154 output-low;
155 line-name = "usb1-reset";
166 remote-endpoint = <&hdmi0_con>;
172 remote-endpoint = <&rsnd_endpoint>;
179 pinctrl-0 = <&hscif0_pins>;
180 pinctrl-names = "default";
182 uart-has-rtscts;
187 dr_mode = "otg";
192 clock-frequency = <400000>;
195 versaclock5: clock-generator@6a {
198 #clock-cells = <1>;
200 clock-names = "xin";
213 clock-frequency = <100000000>;
217 pinctrl-0 = <&scif_clk_pins>;
218 pinctrl-names = "default";
238 power-source = <3300>;
244 power-source = <1800>;
250 power-source = <1800>;
256 power-source = <1800>;
272 bias-pull-up;
283 timeout-sec = <60>;
288 pinctrl-0 = <&scif2_pins>;
289 pinctrl-names = "default";
295 clock-frequency = <14745600>;
299 pinctrl-0 = <&sdhi0_pins>;
300 pinctrl-1 = <&sdhi0_pins_uhs>;
301 pinctrl-names = "default", "state_uhs";
303 vmmc-supply = <®_3p3v>;
304 vqmmc-supply = <&vccq_sdhi0>;
305 cd-gpios = <&gpio3 12 GPIO_ACTIVE_LOW>;
306 bus-width = <4>;
307 sd-uhs-sdr50;
308 sd-uhs-sdr104;
314 pinctrl-0 = <&sdhi2_pins>;
315 pinctrl-names = "default";
317 vmmc-supply = <&wlan_en_reg>;
318 bus-width = <4>;
319 non-removable;
320 cap-power-off-card;
321 keep-power-in-suspend;
323 #address-cells = <1>;
324 #size-cells = <0>;
328 interrupt-parent = <&gpio2>;
334 pinctrl-0 = <&sdhi3_pins>;
335 pinctrl-1 = <&sdhi3_pins>;
336 pinctrl-names = "default", "state_uhs";
338 vmmc-supply = <®_3p3v>;
339 vqmmc-supply = <®_1p8v>;
340 bus-width = <8>;
341 mmc-hs200-1_8v;
342 no-sd;
343 no-sdio;
344 non-removable;
345 fixed-emmc-driver-type = <1>;
350 clock-frequency = <50000000>;
354 pinctrl-0 = <&usb0_pins>;
355 pinctrl-names = "default";
357 vbus-supply = <&vbus0_usb2>;
362 pinctrl-0 = <&usb1_pins>;
363 pinctrl-names = "default";
370 phy-names = "usb";
382 clock-frequency = <100000000>;
386 pinctrl-0 = <&usb30_pins>;
387 pinctrl-names = "default";