Lines Matching +full:mtl +full:- +full:rx +full:- +full:config
1 // SPDX-License-Identifier: (GPL-2.0+ OR MIT)
18 reg_wl_bt: regulator-wifi-bt {
19 compatible = "regulator-fixed";
20 pinctrl-names = "default";
21 pinctrl-0 = <&pinctrl_reg_wl_bt>;
22 regulator-name = "wl-bt-pow-dwn";
23 regulator-min-microvolt = <3300000>;
24 regulator-max-microvolt = <3300000>;
26 startup-delay-us = <70000>;
27 regulator-always-on;
32 cpu-supply = <&buck2>;
36 cpu-supply = <&buck2>;
40 cpu-supply = <&buck2>;
44 cpu-supply = <&buck2>;
48 pinctrl-names = "default";
49 pinctrl-0 = <&pinctrl_eqos>;
50 phy-mode = "rgmii-id";
51 phy-handle = <ðphy0>;
53 snps,mtl-rx-config = <&mtl_rx_setup>;
54 snps,mtl-tx-config = <&mtl_tx_setup>;
58 compatible = "snps,dwmac-mdio";
59 #address-cells = <1>;
60 #size-cells = <0>;
62 ethphy0: ethernet-phy@3 {
63 compatible = "ethernet-phy-id0022.1640",
64 "ethernet-phy-ieee802.3-c22";
66 reset-gpios = <&gpio4 10 GPIO_ACTIVE_LOW>;
67 interrupt-parent = <&gpio1>;
72 mtl_rx_setup: rx-queues-config {
73 snps,rx-queues-to-use = <5>;
76 snps,dcb-algorithm;
78 snps,map-to-dma-channel = <0>;
82 snps,dcb-algorithm;
84 snps,map-to-dma-channel = <1>;
88 snps,dcb-algorithm;
90 snps,map-to-dma-channel = <2>;
94 snps,dcb-algorithm;
96 snps,map-to-dma-channel = <3>;
100 snps,dcb-algorithm;
102 snps,map-to-dma-channel = <4>;
106 mtl_tx_setup: tx-queues-config {
107 snps,tx-queues-to-use = <5>;
110 snps,dcb-algorithm;
115 snps,dcb-algorithm;
120 snps,dcb-algorithm;
125 snps,dcb-algorithm;
130 snps,dcb-algorithm;
137 pinctrl-names = "default";
138 pinctrl-0 = <&pinctrl_flexspi0>;
142 compatible = "jedec,spi-nor";
144 spi-max-frequency = <80000000>;
145 spi-tx-bus-width = <1>;
146 spi-rx-bus-width = <4>;
151 pinctrl-names = "default";
152 pinctrl-0 = <&pinctrl_i2c1>;
153 clock-frequency = <384000>;
159 pinctrl-names = "default";
160 pinctrl-0 = <&pinctrl_pmic>;
161 interrupt-parent = <&gpio1>;
166 regulator-name = "BUCK1";
167 regulator-min-microvolt = <600000>;
168 regulator-max-microvolt = <2187500>;
169 regulator-boot-on;
170 regulator-always-on;
171 regulator-ramp-delay = <3125>;
175 regulator-name = "BUCK2";
176 regulator-min-microvolt = <600000>;
177 regulator-max-microvolt = <2187500>;
178 regulator-boot-on;
179 regulator-always-on;
180 regulator-ramp-delay = <3125>;
181 nxp,dvs-run-voltage = <950000>;
182 nxp,dvs-standby-voltage = <850000>;
186 regulator-name = "BUCK4";
187 regulator-min-microvolt = <3300000>;
188 regulator-max-microvolt = <3300000>;
189 regulator-boot-on;
190 regulator-always-on;
194 regulator-name = "BUCK5";
195 regulator-min-microvolt = <1800000>;
196 regulator-max-microvolt = <1800000>;
197 regulator-boot-on;
198 regulator-always-on;
202 regulator-name = "BUCK6";
203 regulator-min-microvolt = <600000>;
204 regulator-max-microvolt = <3400000>;
205 regulator-boot-on;
206 regulator-always-on;
210 regulator-name = "LDO1";
211 regulator-min-microvolt = <1600000>;
212 regulator-max-microvolt = <1800000>;
213 regulator-boot-on;
214 regulator-always-on;
218 regulator-name = "LDO3";
219 regulator-min-microvolt = <800000>;
220 regulator-max-microvolt = <1800000>;
221 regulator-boot-on;
222 regulator-always-on;
226 regulator-name = "LDO4";
227 regulator-min-microvolt = <800000>;
228 regulator-max-microvolt = <3300000>;
229 regulator-boot-on;
230 regulator-always-on;
234 regulator-name = "LDO5";
235 regulator-min-microvolt = <1800000>;
236 regulator-max-microvolt = <3300000>;
237 regulator-boot-on;
238 regulator-always-on;
245 pinctrl-names = "default";
246 pinctrl-0 = <&pinctrl_i2c3>;
247 clock-frequency = <384000>;
254 read-only; /* Manufacturing EEPROM programmed at factory */
268 pinctrl-names = "default";
269 pinctrl-0 = <&pinctrl_uart1>;
270 assigned-clocks = <&clk IMX8MP_CLK_UART1>;
271 assigned-clock-parents = <&clk IMX8MP_SYS_PLL1_80M>;
272 uart-has-rtscts;
276 compatible = "nxp,88w8997-bt";
281 pinctrl-names = "default", "state_100mhz", "state_200mhz";
282 pinctrl-0 = <&pinctrl_usdhc1>;
283 pinctrl-1 = <&pinctrl_usdhc1_100mhz>;
284 pinctrl-2 = <&pinctrl_usdhc1_200mhz>;
285 bus-width = <4>;
286 vmmc-supply = <®_wl_bt>;
287 cap-sd-highspeed;
288 sd-uhs-sdr50;
289 sd-uhs-sdr104;
290 keep-power-in-suspend;
291 wakeup-source;
292 non-removable;
293 cap-power-off-card;
294 #address-cells = <1>;
295 #size-cells = <0>;
301 pinctrl-names = "default";
302 pinctrl-0 = <&pinctrl_wlan>;
303 interrupt-parent = <&gpio2>;
309 pinctrl-names = "default", "state_100mhz", "state_200mhz";
310 pinctrl-0 = <&pinctrl_usdhc3>;
311 pinctrl-1 = <&pinctrl_usdhc3_100mhz>;
312 pinctrl-2 = <&pinctrl_usdhc3_200mhz>;
313 bus-width = <8>;
314 non-removable;
319 pinctrl-names = "default";
320 pinctrl-0 = <&pinctrl_wdog>;
321 fsl,ext-reset-output;
378 pinctrl_reg_wl_bt: reg-wl-btgrp {
404 pinctrl_usdhc1_100mhz: usdhc1-100mhzgrp {
415 pinctrl_usdhc1_200mhz: usdhc1-200mhzgrp {
442 pinctrl_usdhc3_100mhz: usdhc3-100mhzgrp {
458 pinctrl_usdhc3_200mhz: usdhc3-200mhzgrp {