ti/omap/omap4-duovero.dtsi

1 // SPDX-License-Identifier: GPL-2.0-only
7 #include "omap4-mcpdm.dtsi"
11 	compatible = "gumstix,omap4-duovero", "ti,omap4430", "ti,omap4";
14 		stdout-path = &uart3;
23 		compatible = "ti,abe-twl6040";
26 		ti,mclk-freq = <38400000>;
33 		ti,audio-routing =
36 			"HSMIC", "Headset Mic",
37 			"Headset Mic", "Headset Mic Bias";
42 		compatible = "usb-nop-xceiv";
43 		reset-gpios = <&gpio2 30 GPIO_ACTIVE_LOW>;	/* gpio_62 */
44 		#phy-cells = <0>;
46 		pinctrl-names = "default";
47 		pinctrl-0 = <&hsusb1phy_pins>;
50 		clock-names = "main_clk";
51 		clock-frequency = <19200000>;
56 		pinctrl-names = "default";
57 		pinctrl-0 = <&w2cbw0015_pins>;
58 		compatible = "regulator-fixed";
59 		regulator-name = "w2cbw0015";
60 		regulator-min-microvolt = <3000000>;
61 		regulator-max-microvolt = <3000000>;
63 		startup-delay-us = <70000>;
64 		enable-active-high;
65 		regulator-boot-on;
70 	pinctrl-names = "default";
71 	pinctrl-0 = <
76 	twl6040_pins: twl6040-pins {
77 		pinctrl-single,pins = <
83 	mcbsp1_pins: mcbsp1-pins {
84 		pinctrl-single,pins = <
92 	hsusbb1_pins: hsusbb1-pins {
93 		pinctrl-single,pins = <
109 	hsusb1phy_pins: hsusb1phy-pins {
110 		pinctrl-single,pins = <
115 	w2cbw0015_pins: w2cbw0015-pins {
116 		pinctrl-single,pins = <
122 	i2c1_pins: i2c1-pins {
123 		pinctrl-single,pins = <
129 	i2c4_pins: i2c4-pins {
130 		pinctrl-single,pins = <
136 	mmc1_pins: mmc1-pins {
137 		pinctrl-single,pins = <
147 	mmc5_pins: mmc5-pins {
148 		pinctrl-single,pins = <
161 	pinctrl-names = "default";
162 	pinctrl-0 = <&i2c1_pins>;
164 	clock-frequency = <400000>;
173 		#clock-cells = <0>;
176 		ti,audpwron-gpio = <&gpio6 0 GPIO_ACTIVE_HIGH>;		/* gpio_160 */
178 		vio-supply = <&v1v8>;
179 		v2v1-supply = <&v2v1>;
180 		enable-active-high;
187 /* on-board bluetooth / WiFi module */
189 	pinctrl-names = "default";
190 	pinctrl-0 = <&i2c4_pins>;
192 	clock-frequency = <400000>;
196 	pinctrl-names = "default";
197 	pinctrl-0 = <&mcbsp1_pins>;
202 	pinctrl-names = "default";
203 	pinctrl-0 = <&mmc1_pins>;
205 	vmmc-supply = <&vmmc>;
206 	ti,bus-width = <4>;
207 	ti,non-removable;		/* FIXME: use PMIC_MMC detect */
220 /* on-board WiFi module */
222 	pinctrl-names = "default";
223 	pinctrl-0 = <&mmc5_pins>;
225 	vmmc-supply = <&w2cbw0015_vmmc>;
226 	ti,bus-width = <4>;
227 	ti,non-removable;
228 	cap-power-off-card;
229 	keep-power-in-suspend;
233 	usb-supply = <&vusb>;
237 	interface-type = <1>;
243 	port1-mode = "ehci-phy";