Lines Matching +full:err006687 +full:- +full:workaround +full:- +full:present
3 * Copyright 2017 Savoir-Faire Linux
5 * This file is dual-licensed: you can use it either under the terms
43 #include <dt-bindings/gpio/gpio.h>
44 #include <dt-bindings/interrupt-controller/irq.h>
48 pinctrl-names = "default";
49 pinctrl-0 = <&pinctrl_leds1>;
50 compatible = "gpio-leds";
52 green-led {
53 label = "green-led";
55 default-state = "on";
58 red-led {
59 label = "red-led";
61 default-state = "off";
64 yel-led {
65 label = "yellow-led";
67 default-state = "off";
70 blue-led {
71 label = "blue-led";
73 default-state = "off";
76 en-usb-5v-led {
77 label = "en-usb-5v";
79 default-state = "on";
82 sel-dc-usb-led {
85 default-state = "off";
90 reg_3p3v: regulator-3p3v {
91 compatible = "regulator-fixed";
92 regulator-name = "3p3v";
93 regulator-min-microvolt = <3300000>;
94 regulator-max-microvolt = <3300000>;
95 regulator-always-on;
99 compatible = "regulator-fixed";
100 regulator-name = "reg_can1_3v3";
101 regulator-min-microvolt = <3300000>;
102 regulator-max-microvolt = <3300000>;
104 enable-active-high;
107 reg_can2_3v3: en-reg_can2_3v3 {
108 compatible = "regulator-fixed";
109 regulator-name = "reg_can2_3v3";
110 regulator-min-microvolt = <3300000>;
111 regulator-max-microvolt = <3300000>;
113 enable-active-high;
116 reg_usb_otg_vbus: regulator-usb-otg-vbus {
117 compatible = "regulator-fixed";
118 regulator-name = "usb_otg_vbus";
119 regulator-min-microvolt = <5000000>;
120 regulator-max-microvolt = <5000000>;
122 enable-active-high;
126 compatible = "regulator-fixed";
127 regulator-name = "wlan_vmmc";
128 regulator-min-microvolt = <1800000>;
129 regulator-max-microvolt = <1800000>;
131 startup-delay-us = <70000>;
132 enable-active-high;
135 sound-sgtl5000 {
136 audio-codec = <&sgtl5000>;
137 audio-routing =
141 compatible = "fsl,imx-audio-sgtl5000";
142 model = "On-board Codec";
143 mux-ext-port = <3>;
144 mux-int-port = <1>;
145 ssi-controller = <&ssi1>;
154 pinctrl-names = "default";
155 pinctrl-0 = <&pinctrl_flexcan1>;
156 xceiver-supply = <®_can1_3v3>;
161 pinctrl-names = "default";
162 pinctrl-0 = <&pinctrl_flexcan2>;
163 xceiver-supply = <®_can2_3v3>;
168 cs-gpios = <&gpio3 19 GPIO_ACTIVE_LOW>;
169 pinctrl-names = "default";
170 pinctrl-0 = <&pinctrl_ecspi1>;
174 compatible = "micron,n25q064", "jedec,spi-nor";
176 spi-max-frequency = <20000000>;
181 cs-gpios = <
186 pinctrl-names = "default";
187 pinctrl-0 = <&pinctrl_ecspi2>;
192 pinctrl-names = "default";
193 pinctrl-0 = <&pinctrl_enet>;
194 phy-mode = "rgmii";
195 /delete-property/ interrupts;
196 interrupts-extended = <&gpio1 6 IRQ_TYPE_LEVEL_HIGH>,
198 fsl,err006687-workaround-present;
207 clock-frequency = <100000>;
208 pinctrl-names = "default", "gpio";
209 pinctrl-0 = <&pinctrl_i2c1>;
210 pinctrl-1 = <&pinctrl_i2c1_gpio>;
211 scl-gpios = <&gpio3 21 GPIO_ACTIVE_HIGH>;
212 sda-gpios = <&gpio3 28 GPIO_ACTIVE_HIGH>;
226 compatible = "technologic,ts7970-gpio";
228 #gpio-cells = <2>;
229 gpio-controller;
235 pinctrl-names = "default";
236 pinctrl-0 = <&pinctrl_sgtl5000>;
238 #sound-dai-cells = <0>;
240 VDDA-supply = <®_3p3v>;
241 VDDIO-supply = <®_3p3v>;
246 clock-frequency = <100000>;
247 pinctrl-names = "default", "gpio";
248 pinctrl-0 = <&pinctrl_i2c2>;
249 pinctrl-1 = <&pinctrl_i2c2_gpio>;
250 scl-gpios = <&gpio4 12 GPIO_ACTIVE_HIGH>;
251 sda-gpios = <&gpio4 13 GPIO_ACTIVE_HIGH>;
256 pinctrl-names = "default";
257 pinctrl-0 = <&pinctrl_hog>;
515 pinctrl-names = "default";
516 pinctrl-0 = <&pinctrl_uart1>;
521 pinctrl-names = "default";
522 pinctrl-0 = <&pinctrl_uart2>;
523 uart-has-rtscts;
528 pinctrl-names = "default";
529 pinctrl-0 = <&pinctrl_uart3>;
534 pinctrl-names = "default";
535 pinctrl-0 = <&pinctrl_uart4>;
540 pinctrl-names = "default";
541 pinctrl-0 = <&pinctrl_uart5>;
550 vbus-supply = <®_usb_otg_vbus>;
551 pinctrl-names = "default";
552 pinctrl-0 = <&pinctrl_usbotg>;
553 disable-over-current;
559 pinctrl-names = "default";
560 pinctrl-0 = <&pinctrl_usdhc1>;
561 vmmc-supply = <®_wlan_vmmc>;
562 bus-width = <4>;
563 non-removable;
564 #address-cells = <1>;
565 #size-cells = <0>;
571 interrupt-parent = <&gpio1>;
573 ref-clock-frequency = <38400000>;
579 pinctrl-names = "default";
580 pinctrl-0 = <&pinctrl_usdhc2>;
581 vmmc-supply = <®_3p3v>;
582 bus-width = <4>;
583 fsl,wp-controller;
589 pinctrl-names = "default";
590 pinctrl-0 = <&pinctrl_usdhc3>;
591 vmmc-supply = <®_3p3v>;
592 bus-width = <4>;
593 non-removable;