dts/allwinner/sun4i-a10-cubieboard.dts

5  * This file is dual-licensed: you can use it either under the terms
44 /dts-v1/;
45 #include "sun4i-a10.dtsi"
46 #include "sunxi-common-regulators.dtsi"
48 #include <dt-bindings/gpio/gpio.h>
52 	compatible = "cubietech,a10-cubieboard", "allwinner,sun4i-a10";
59 		stdout-path = "serial0:115200n8";
62 	hdmi-connector {
63 		compatible = "hdmi-connector";
68 				remote-endpoint = <&hdmi_out_con>;
74 		compatible = "gpio-leds";
75 		pinctrl-names = "default";
76 		pinctrl-0 = <&led_pins_cubieboard>;
78 		led-0 {
83 		led-1 {
86 			linux,default-trigger = "heartbeat";
92 	target-supply = <&reg_ahci_5v>;
101 	cpu-supply = <&reg_dcdc2>;
117 	phy-handle = <&phy1>;
125 &hdmi {
131 		remote-endpoint = <&hdmi_con_in>;
149 	pinctrl-names = "default";
150 	pinctrl-0 = <&ir0_rx_pins>;
157 	phy1: ethernet-phy@1 {
163 	vmmc-supply = <&reg_vcc3v3>;
164 	bus-width = <4>;
165 	cd-gpios = <&pio 7 1 GPIO_ACTIVE_LOW>; /* PH1 */
182 	led_pins_cubieboard: led-pins {
185 		drive-strength = <20>;
200 	regulator-always-on;
201 	regulator-min-microvolt = <1000000>;
202 	regulator-max-microvolt = <1450000>;
203 	regulator-name = "vdd-cpu";
207 	regulator-always-on;
208 	regulator-min-microvolt = <1000000>;
209 	regulator-max-microvolt = <1400000>;
210 	regulator-name = "vdd-int-dll";
214 	regulator-name = "vdd-rtc";
218 	regulator-always-on;
219 	regulator-min-microvolt = <3000000>;
220 	regulator-max-microvolt = <3000000>;
221 	regulator-name = "avcc";
233 	pinctrl-names = "default";
234 	pinctrl-0 = <&spi0_pi_pins>,
240 	pinctrl-names = "default";
241 	pinctrl-0 = <&uart0_pb_pins>;
251 	usb0_id_det-gpios = <&pio 7 4 (GPIO_ACTIVE_HIGH | GPIO_PULL_UP)>; /* PH4 */
252 	usb1_vbus-supply = <&reg_usb1_vbus>;
253 	usb2_vbus-supply = <&reg_usb2_vbus>;