w1/slaves/w1_therm.rst

16 -----------
49 -1 if at least one sensor still in conversion, 1 if conversion is complete
65 auto measure and set a conversion time by writing ``1`` to
72 the sensor. Resolution is reset when the sensor gets power-cycled.
81 Some non-genuine DS18B20 chips are fixed in 12-bit mode only, so the actual
86 The write-only sysfs entry ``eeprom_cmd`` is an alternative for EEPROM operations.
94 Values shall be space separated and in the device range (typical -55 degC
104 In case the detection of parasite devices using this command fails
106 be force-enabled.
117 detection algorithm.  This feature allows you to determine the physical
118 location of the chip in the 1-wire bus without needing pre-existing
126 detection of invalid conversion. Write bit mask ``1`` to ``features`` to enable
133 Documentation/ABI/testing/sysfs-driver-w1_therm
136 compatible with DS18B20. Added are lowest 2\ :sup:`-5`, 2\ :sup:`-6` temperature
138 resolutions. The device is powered up in 14-bit resolution mode. The conversion
144 indicating 15, but the device is always operating in 14-bit resolution mode.