Documentation/networking/pktgen.rst

1 .. SPDX-License-Identifier: GPL-2.0
7 Enable CONFIG_NET_PKTGEN to compile and build pktgen either in-kernel
31 overload type of benchmarking, as this could hurt the normal use-case.
35  # ethtool -G ethX tx 1024
44 ring-buffers for various performance reasons, and packets stalling
49 and the cleanup interval is affected by the ethtool --coalesce setting
50 of parameter "rx-usecs".
54  # ethtool -C ethX rx-usecs 30
72  * add_device DEVICE@NAME -- adds a single device
73  * rem_device_all         -- remove all associated devices
83 The part after "@" can be anything, but it is custom to use the thread
106 	pkts-sofar: 100000  errors: 0
161  pgset "src_mac_count 1" Sets the number of MACs we'll range through.
164  pgset "dst_mac_count 1" Sets the number of MACs we'll range through.
190 			 cycle through the port range.
194 			 cycle through the port range.
213  pgset "vlan_id 77"       set VLAN ID 0-4095
214  pgset "vlan_p 3"         set priority bit 0-7 (default 0)
215  pgset "vlan_cfi 0"       set canonical format identifier 0-1 (default 0)
217  pgset "svlan_id 22"      set SVLAN ID 0-4095
218  pgset "svlan_p 3"        set priority bit 0-7 (default 0)
219  pgset "svlan_cfi 0"      set canonical format identifier 0-1 (default 0)
244  ./pktgen_sample01_simple.sh -i eth4 -m 00:1B:21:3C:9D:F8 -d 192.168.8.2
248   ./pktgen_sample01_simple.sh [-vx] -i ethX
250   -i : ($DEV)       output interface/device (required)
251   -s : ($PKT_SIZE)  packet size
252   -d : ($DEST_IP)   destination IP. CIDR (e.g. 198.18.0.0/15) is also allowed
253   -m : ($DST_MAC)   destination MAC-addr
254   -p : ($DST_PORT)  destination PORT range (e.g. 433-444) is also allowed
255   -t : ($THREADS)   threads to start
256   -f : ($F_THREAD)  index of first thread (zero indexed CPU number)
257   -c : ($SKB_CLONE) SKB clones send before alloc new SKB
258   -n : ($COUNT)     num messages to send per thread, 0 means indefinitely
259   -b : ($BURST)     HW level bursting of SKBs
260   -v : ($VERBOSE)   verbose
261   -x : ($DEBUG)     debug
262   -6 : ($IP6)       IPv6
263   -w : ($DELAY)     Tx Delay value (ns)
264   -a : ($APPEND)    Script will not reset generator's state, but will append its config
267 interface/device parameter "-i" sets variable $DEV.  Copy the
295 To test with non-shared SKBs, remove the "SHARED" flag by simply setting::
410 - ftp://robur.slu.se/pub/Linux/net-development/pktgen-testing/
411 - ftp://robur.slu.se/pub/Linux/net-development/pktgen-testing/examples/
413 Paper from Linux-Kongress in Erlangen 2004.
414 - ftp://robur.slu.se/pub/Linux/net-development/pktgen-testing/pktgen_paper.pdf
418 Grant Grundler for testing on IA-64 and parisc, Harald Welte,  Lennert Buytenhek
422 Good luck with the linux net-development.