mellanox/mlx5/counters.rst

74   Traffic counters and drops due to steering or no buffers. May indicate issues
75   with NIC. These counters include Ethernet traffic counters (including Raw
76   Ethernet) and RDMA/RoCE traffic counters.
93 Traffic Informative Counters
94   Counters which count traffic. These counters can be used for load estimation
97 Traffic Acceleration Counters
98   Counters which count traffic that was accelerated by Mellanox driver or by
100   and the same traffic is counted in both informative and acceleration counters.
102 .. [#accel] Traffic acceleration counter.
127 These counters provide information on the amount of traffic that was accelerated
128 by the NIC. The counters are counting the accelerated traffic in addition to the
129 standard counters which counts it (i.e. accelerated traffic is counted twice).
252        traffic. It might imply that the device MTU is larger than the software
519        traffic rx over all queues and/or increase rx ring size.
754        QP/DPDK traffic, excluding RDMA traffic.
759        traffic, excluding RDMA traffic.
764        QP/DPDK traffic, excluding RDMA traffic.
769        QP/DPDK traffic, excluding RDMA traffic.
774        QP/DPDK traffic, excluding RDMA traffic.
779        QP/DPDK traffic, excluding RDMA traffic.
784        QP/DPDK traffic, excluding RDMA traffic.
789        QP/DPDK traffic, excluding RDMA traffic.
794        QP/DPDK traffic, excluding RDMA traffic.
799        QP/DPDK traffic, excluding RDMA traffic.
804        QP/DPDK traffic, excluding RDMA traffic.
809        QP/DPDK traffic, excluding RDMA traffic.
814        RoCE/UD/RC traffic) [#accel]_.
819        RoCE/UD/RC traffic) [#accel]_.
824        RoCE/UD/RC traffic) [#accel]_.
829        RoCE/UD/RC traffic) [#accel]_.
834        RoCE/UD/RC traffic) [#accel]_.
839        RoCE/UD/RC traffic) [#accel]_.
844        RoCE/UD/RC traffic) [#accel]_.
849        RoCE/UD/RC traffic) [#accel]_.
980        cannot absorb the traffic coming from to the adapter.
986        cannot absorb the traffic coming from the network.
997        is congested and cannot absorb the traffic coming from the network.
1087        adapter's incoming traffic.
1131      - This counter provides information on the total amount of traffic that
1133        ratio of errored traffic in `rx_pcs_symbol_err_phy` and
1142        traffic is lost. You may need to replace the cable/transceiver. The error
1159        suffering from high BER, and that traffic might be lost. You may need to
1167        cannot absorb the traffic coming from the adapter. Note: This counter is
1173        counter represents the time the port did not send any traffic. If this
1175        cannot absorb the traffic coming from the adapter. Note: This counter is
1182        cannot absorb the traffic coming from the network. Note: This counter is
1234        and cannot absorb the traffic coming from the adapter. Note: This counter
1241        traffic on this priority. If this counter is increasing, it implies that
1242        the network is congested and cannot absorb the traffic coming from the
1256        and cannot absorb the traffic coming from the network. Note: This counter
1311        is raising in high rate, it might indicate that the receive traffic rate