Lines Matching refs:parameter
36 The default value for each parameter is generally the recommended setting,
57 This parameter is a bit-mask that specifies the speed and duplex settings
58 advertised by the adapter. When this parameter is used, the Speed and
63 information on the AutoNeg parameter.
85 This parameter controls the automatic generation(Tx) and response(Rx)
231 (This parameter is supported only on 82540, 82545 and later adapters.)
246 (This parameter is supported only on adapters with copper connections.)
252 (Mbps). If this parameter is not specified or is set to 0 and the link
288 (This parameter is supported only on 82540, 82545 and later adapters.)
303 (This parameter is NOT supported on the 82542-based adapter.)
321 This parameter is different than other parameters, in that it is a
322 single (not 1,1,1 etc.) parameter applied to all driver instances and
333 this parameter in supported chipsets.
354 negotiation is disabled, and the AutoNeg parameter is ignored. Partner
357 The AutoNeg parameter is used when more control is required over the
362 The parameter may be specified as either a decimal or hexadecimal value as
385 Note that when this parameter is used, Speed and Duplex must not be specified.
388 parameter should not be used. Instead, use the Speed and Duplex parameters