15 - Speed and Duplex Configuration
40 	For more information about the AutoNeg, Duplex, and Speed
41         parameters, see the "Speed and Duplex Configuration" section in
59 Duplex parameters must not be specified.
62        Refer to the Speed and Duplex section of this readme for more
65 Duplex  section in Command Line Parameters
74 either one or two-directional.  If both Duplex and the link partner are
76 link partner is forced (either full or half), Duplex defaults to half-
254 speed.  Duplex should also be set when Speed is set to either 10 or 100.
335 Speed and Duplex Configuration
339 These keywords are Speed, Duplex, and AutoNeg.
353 - If Speed = 10 or 100, then both Speed and Duplex should be set.  Auto-
370 Duplex                       Full            Full   Half   Full    Half
385 Note that when this parameter is used, Speed and Duplex must not be specified.
388 parameter should not be used.  Instead, use the Speed and Duplex parameters