device_drivers/atm/cxacru.rst

1 .. SPDX-License-Identifier: GPL-2.0
11 driver and it is necessary to unplug/remove power to the device to fix this.
13 Note: support for cxacru-cf.bin has been removed. It was not loaded correctly
17 There is a script cxacru-cf.py to convert an existing file to the sysfs form.
21 named device points to the USB interface device's directory which contains
29 	- Information about the remote headend.
33 	- Configuration writing interface.
34 	- Write parameters in hexadecimal format <index>=<value>,
39 	- Up to 7 parameters at a time will be sent and the modem will restart
48 	- Downstream stats.
56 	- Upstream stats.
65 	- Error counts.
69 	- Indicates that ADSL support on the device
74 	 - "initialising"
75 	 - "down"
76 	 - "attempting to activate"
77 	 - "training"
78 	 - "channel analysis"
79 	 - "exchange"
80 	 - "waiting"
81 	 - "up"
83 	Changes between "down" and "attempting to activate"
88 	 - "not connected"
89 	 - "connected"
90 	 - "lost"
96 	 - "" (when not connected)
97 	 - "ANSI T1.413"
98 	 - "ITU-T G.992.1 (G.DMT)"
99 	 - "ITU-T G.992.2 (G.LITE)"
103 	- Count of total attempts to initialise ADSL.
105 To enable/disable ADSL, the following can be written to the adsl_state file:
107 	 - "start"
108 	 - "stop
109 	 - "restart" (stops, waits 1.5s, then starts)
110 	 - "poll" (used to resume status polling if it was disabled due to failure)
116 	[4942249.665075] ATM dev 0: ADSL line: attempting to activate