Lines Matching full:eth1
1289 must correspond with the name of the file, i.e., ifcfg-eth1 must have
1290 a device line of DEVICE=eth1. The setting of the MASTER= line will
1392 devices (presumed to be eth0 and eth1), and have it persist across
1400 ip link set eth1 master bond0
1622 and eth1), and have it persist across reboots, edit the appropriate
1632 echo +eth1 > /sys/class/net/bond0/bonding/slaves
1666 active-backup mode, with eth0 and eth1 as slaves::
1670 bond-slaves eth0 eth1
1673 bond-primary eth0 eth1
1689 bond-primary eth0 eth1
1691 auto eth1
1692 iface eth1 inet manual
1694 bond-primary eth0 eth1
1709 bonded interface in which eth0 connects to a private network, while eth1
1711 traffic over eth0 first, using eth1 only as a fall back, while all other traffic
1738 Slave Interface: eth1
1746 # echo "eth1:2" > /sys/class/net/bond0/bonding/queue_id
1756 force all traffic bound to 192.168.1.100 to use eth1 in the bond as its output
1768 selection policy to be overridden, selecting instead qid 2, which maps to eth1.
1850 Slave Interface: eth1
1870 (MASTER) while eth0 and eth1 are slaves (SLAVE). Notice all slaves of
1889 eth1 Link encap:Ethernet HWaddr 00:C0:F0:1F:37:B4
2058 device bond0 has two slaves, eth0 and eth1, and the routing table is
2064 10.0.0.0 0.0.0.0 255.255.0.0 U 40 0 0 eth1
2071 case, another host on network 10 would use eth0 or eth1 before bond0).
2101 alias eth1 tg3
2105 If neither eth0 and eth1 are slaves to bond0, then when the
2109 when the e1000 driver loads, it will receive eth0 and eth1 for its
2167 eth1 are slaves of bond0 and the driver for eth0 is loaded before the
2177 interfaces.ifTable.ifEntry.ifDescr.3 = eth1
2194 interfaces.ifTable.ifEntry.ifDescr.4 = eth1
2278 eth0 +-------+ eth1
2363 | |eth1 port2| | here somewhere
2390 | |eth1 port2| +------------------+ Host C |
2717 I/O Module #1; similarly, all eth1 ports are wired to I/O Module #2.
2741 modules 1 and 2. In this configuration, the eth0 and eth1 ports of a
2747 switch. By using PMs in I/O module #1 and #2, the eth0 and eth1