Lines Matching full:temperature
87 The chips implement 3 to 4 temperature sensors (9 for NCT6775F and NCT6776F),
92 The temperature sensor sources on W82677HG-B, NCT6775F, and NCT6776F are
93 configurable. temp4 and higher attributes are only reported if its temperature
94 source differs from the temperature sources of the already reported temperature
95 sensors. The configured source for each of the temperature sensors is provided
101 An alarm is triggered when the temperature gets higher than high limit;
102 it stays on until the temperature falls below the hysteresis value.
117 In this mode, the chip attempts to keep the measured temperature in a
118 predefined temperature range. If the temperature goes out of range, fan
144 this file controls mode of fan/temperature control:
172 If the temperature is in the range defined by:
175 set target temperature, unit millidegree Celsius
180 there are no changes to fan speed. Once the temperature leaves the interval,
185 minimum fan speed (range 1 - 255), when the temperature
189 corresponding fan off. (when the temperature was below
198 maximum fan speed (range 1 - 255), when the temperature
216 0x49 only on DHG, selects temperature source for AUX fan,
220 and 6, including extending the temperature input
226 temperature detection and critical temperature
233 0x6b only on DHG, SYS fan critical temperature
234 0x6c only on DHG, CPU fan0 critical temperature
235 0x6d only on DHG, AUX fan critical temperature
236 0x6e only on DHG, CPU fan1 critical temperature