Documentation/hwmon/sht3x.rst

6   * Sensirion SHT3x-DIS
13         - https://sensirion.com/media/documents/213E6A3B/63A5A569/Datasheet_SHT3x_DIS.pdf
14 …- https://sensirion.com/media/documents/051DF50B/639C8101/Sensirion_Humidity_and_Temperature_Senso…
16   * Sensirion STS3x-DIS
23 …- https://sensirion.com/media/documents/1DA31AFD/61641F76/Sensirion_Temperature_Sensors_STS3x_Data…
24 …      - https://sensirion.com/media/documents/292A335C/65537BAF/Sensirion_Datasheet_STS32_STS33.pdf
28   - David Frey <david.frey@sensirion.com>
29   - Pascal Sachs <pascal.sachs@sensirion.com>
32 -----------
34 This driver implements support for the Sensirion SHT3x-DIS and STS3x-DIS
36 celsius, relative humidity is expressed as a percentage. In the sysfs interface,
37 all values are scaled by 1000, i.e. the value for 31.5 degrees celsius is 31500.
41 Documentation/i2c/instantiating-devices.rst for methods to instantiate the
44 Even if sht3x sensor supports clock-stretch (blocking mode) and non-stretch
45 (non-blocking mode) in single-shot mode, this driver only supports the latter.
62 reading exceeds the configured limits, the alert attribute is set to 1 and
63 the alert pin on the sensor is set to high.
65 values, the alert bit is set to 0 and the alert pin on the sensor is set to
72 sysfs-Interface
73 ---------------
93 			- 0: turned off
94 			- 1: turned on
102                         - 0: low repeatability
103                         - 1: medium repeatability
104                         - 2: high repeatability
107 debugfs-Interface
108 -----------------