Documentation/hwmon/pmbus.rst

12     Addresses scanned: -
23     Addresses scanned: -
27 	https://www.onsemi.com/pub_link/Collateral/ADP4000-D.PDF
29 	https://www.onsemi.com/pub_link/Collateral/NCP4200-D.PDF
31 	https://www.onsemi.com/pub_link/Collateral/JUNE%202009-%20REV.%200.PDF
33   * Lineage Power
37     Addresses scanned: -
55     Addresses scanned: -
73     Addresses scanned: -
83     Addresses scanned: -
88 Author: Guenter Roeck <linux@roeck-us.net>
92 -----------
95 It supports voltage, current, power, and temperature sensors as supported
98 Each monitored channel has its own high and low limits, plus a critical
105 -----------
116 	$ echo ltc2978 0x60 > /sys/bus/i2c/devices/i2c-1/new_device
120 ---------------------
124 Emerson DS1200 power modules might look as follows::
182 -------------
190 The following attributes are supported. Limits are read-write; all other
191 attributes are read-only.
203 inX_min_alarm		Voltage low alarm. From VOLTAGE_UV_WARNING status.
205 inX_lcrit_alarm		Voltage critical low alarm.
226 currX_lcrit_alarm	Output current critical low alarm.
236 powerX_input		Measured power. From READ_PIN or READ_POUT register.
237 powerX_cap		Output power cap. From POUT_MAX register.
238 powerX_max		Power limit. From PIN_OP_WARN_LIMIT or
240 powerX_crit		Critical output power limit.
242 powerX_alarm		Power high alarm.
244 powerX_crit_alarm	Output power critical high alarm.
249 powerX_rated_max	Maximum rated power.
256 tempX_lcrit		Critical low temperature.
260 tempX_min_alarm		Chip temperature low alarm. Set by comparing
266 tempX_lcrit_alarm	Chip temperature critical low alarm. Set by comparing