Documentation/hwmon/nct6775.rst

15     Addresses scanned: ISA address retrieved from Super I/O registers
19   * Nuvoton NCT5572D/NCT6771F/NCT6772F/NCT6775F/W83677HG-I
23     Addresses scanned: ISA address retrieved from Super I/O registers
31     Addresses scanned: ISA address retrieved from Super I/O registers
39     Addresses scanned: ISA address retrieved from Super I/O registers
47     Addresses scanned: ISA address retrieved from Super I/O registers
55     Addresses scanned: ISA address retrieved from Super I/O registers
63     Addresses scanned: ISA address retrieved from Super I/O registers
71     Addresses scanned: ISA address retrieved from Super I/O registers
79     Addresses scanned: ISA address retrieved from Super I/O registers
83   * Nuvoton NCT6796D-S/NCT6799D-R
87     Addresses scanned: ISA address retrieved from Super I/O registers
93 	Guenter Roeck <linux@roeck-us.net>
96 -----------
99 and compatible super I/O chips.
138 The mode works for fan1-fan5.
141 ----------------
143 pwm[1-7]
144     - this file stores PWM duty cycle or DC value (fan speed) in range:
148 pwm[1-7]_enable
149     - this file controls mode of fan/temperature control:
151 	* 0 Fan control disabled (fans set to maximum speed)
152 	* 1 Manual mode, write to pwm[0-5] any value 0-255
158 pwm[1-7]_mode
159     - controls if output is PWM or DC level
165 -----------------------------
167 pwm[1-7]_temp_sel
171 pwm[1-7]_weight_temp_sel
174 			Set to 0 to disable secondary temperature control.
179 pwm[1-7]_weight_duty_step
182 pwm[1-7]_weight_temp_step
187 pwm[1-7]_weight_temp_step_base
191 pwm[1-7]_weight_temp_step_tol
195 -----------------------
199 pwm[1-7]_target_temp
201 			(range 0 - 127000)
203 pwm[1-7]_temp_tolerance
211 pwm[1-7]_start
212 			fan pwm start value (range 1 - 255), to start fan
215 pwm[1-7]_floor
216 			lowest fan pwm (range 0 - 255) if temperature is below
217 			the defined range. If set to 0, the fan is expected to
220 pwm[1-7]_step_up_time
223 pwm[1-7]_step_down_time
226 pwm[1-7]_stop_time
232 ---------------------
236 fan[1-7]_target
239 fan[1-7]_tolerance
246 ---------------------
252 points should be set to higher temperatures and higher pwm values to achieve
256 pwm[1-7]_auto_point[1-7]_pwm
257 			pwm value to be set if temperature reaches matching
260 pwm[1-7]_auto_point[1-7]_temp
263 pwm[1-7]_temp_tolerance
266 pwm[1-7]_crit_temp_tolerance
270 pwm[1-7]_step_up_time
273 pwm[1-7]_step_down_time
277 -----------
280 connected to anything and floats, or that it is connected to some non-standard
284 temperature increases (similar to the raw PECI temperature value - see PECI
288 NCT6796D-S and NCT6799D-R chips are very similar and their chip_id indicates