Lines Matching full:temperature

101 The chips support up to 25 temperature monitoring sources. Up to 6 of those are
102 direct temperature sensor inputs, the others are special sources such as PECI,
103 PCH, and SMBUS. Depending on the chip type, 2 to 6 of the temperature sources
110 The temperature sensor sources on all chips are configurable. The configured
111 source for each of the temperature sensors is provided in tempX_label.
114 either 1 degC or 0.5 degC, depending on the temperature source and
115 configuration. An alarm is triggered when the temperature gets higher than
116 the high limit; it stays on until the temperature falls below the hysteresis
134 In this mode, the chip attempts to keep the measured temperature in a
135 predefined temperature range. If the temperature goes out of range, fan
149     - this file controls mode of fan/temperature control:
168 			Temperature source. Value is temperature sensor index.
172 			Secondary temperature source. Value is temperature
174 			Set to 0 to disable secondary temperature control.
176 If secondary temperature functionality is enabled, it is controlled with the
183 			Temperature step size. With each step over
188 			Temperature at which secondary temperature control kicks
192 			Temperature step tolerance.
197 If the temperature is in the range defined by:
200 			Target temperature, unit millidegree Celsius
204 			Target temperature tolerance, unit millidegree Celsius
206 There are no changes to fan speed. Once the temperature leaves the interval, fan
207 speed increases (if temperature is higher that desired) or decreases (if
208 temperature is lower than desired), using the following limits and time
213 			when the temperature is above defined range.
216 			lowest fan pwm (range 0 - 255) if temperature is below
218 			stop if the temperature is below the defined range.
228 			corresponding fan off (when the temperature was below
249 controlled by setting the pwm and temperature attributes. When the temperature
253 higher fan speeds with increasing temperature. The last data point reflects
254 critical temperature mode, in which the fans should run at full speed.
257 			pwm value to be set if temperature reaches matching
258 			temperature range.
261 			Temperature over which the matching pwm is enabled.
264 			Temperature tolerance, unit millidegree Celsius
267 			Temperature tolerance for critical temperature,
281 temperature measurement device. As a result, the temperature reported on CPUTIN
283 temperatures, and in some cases the reported temperature declines if the actual
284 temperature increases (similar to the raw PECI temperature value - see PECI
286 boards. The CPU temperature on ASUS boards is reported from PECI 0 or TSI 0.