Documentation/hwmon/max16065.rst

11     Addresses scanned: -
15 	http://datasheets.maxim-ic.com/en/ds/MAX16065-MAX16066.pdf
21     Addresses scanned: -
25 	http://datasheets.maxim-ic.com/en/ds/MAX16067.pdf
31     Addresses scanned: -
35 	http://datasheets.maxim-ic.com/en/ds/MAX16068.pdf
41     Addresses scanned: -
45 	http://datasheets.maxim-ic.com/en/ds/MAX16070-MAX16071.pdf
47 Author: Guenter Roeck <linux@roeck-us.net>
51 -----------
53 [From datasheets] The MAX16065/MAX16066 flash-configurable system managers
55 accurately monitor (+/-2.5%) one current channel using a dedicated high-side
56 current-sense amplifier. The MAX16065 manages up to twelve system voltages
59 The MAX16067 flash-configurable system manager monitors and sequences multiple
62 The MAX16068 flash-configurable system manager monitors and manages up to six
65 The MAX16070/MAX16071 flash-configurable system monitors supervise multiple
66 system voltages. The MAX16070/MAX16071 can also accurately monitor (+/-2.5%)
67 one current channel using a dedicated high-side current-sense amplifier. The
71 Each monitored channel has its own low and high critical limits. MAX16065,
73 configurable as either low or high secondary limit. MAX16065, MAX16066,
74 MAX16070, and MAX16071 also support supply current monitoring.
78 -----------
82 the devices explicitly. Please see Documentation/i2c/instantiating-devices.rst for
94 -------------
97 in[0-11]_input		Input voltage measurements.
99 in12_input		Voltage on CSP (Current Sense Positive) pin.
100 			Only if the chip supports current sensing and if
101 			current sensing is enabled.
103 in[0-11]_min		Low warning limit.
107 in[0-11]_max		High warning limit.
111 			Either low or high warning limits are supported
114 in[0-11]_lcrit		Low critical limit.
116 in[0-11]_crit		High critical limit.
118 in[0-11]_alarm		Input voltage alarm.
120 curr1_input		Current sense input; only if the chip supports current
121 			sensing and if current sensing is enabled.
122 			Displayed current assumes 0.001 Ohm current sense
125 curr1_alarm		Overcurrent alarm; only if the chip supports current
126 			sensing and if current sensing is enabled.