Documentation/hwmon/ltc2945.rst

10     Addresses scanned: -
14 	https://www.analog.com/media/en/technical-documentation/data-sheets/2945fb.pdf
16 Author: Guenter Roeck <linux@roeck-us.net>
20 -----------
22 The LTC2945  is a rail-to-rail system monitor that measures current, voltage,
27 -----------
37 	$ echo ltc2945 0x10 > /sys/bus/i2c/devices/i2c-1/new_device
41 -------------
49 Current reading provided by this driver is reported as obtained from the ADC
50 Current Sense register. The reported value assumes that a 1 mOhm sense resistor
51 is installed. If a different sense resistor is installed, calculate the real
52 current by dividing the reported value by the sense resistor value in mOhm.
56 			SENSE+ or VDD pin depending on chip configuration.
74 curr1_input		SENSE current (mA)
77 curr1_lowest		Lowest measured current
78 curr1_highest		Highest measured current
83 power1_input		Power (in uW). Power is calculated based on SENSE+/VDD