bindings/usb/da8xx-usb.txt

3 For DA8xx/OMAP-L1x/AM17xx/AM18xx platforms.
7  - compatible : Should be set to "ti,da830-musb".
9  - reg: Offset and length of the USB controller register set.
11  - interrupts: The USB interrupt number.
13  - interrupt-names: Should be set to "mc".
15  - dr_mode: The USB operation mode. Should be one of "host", "peripheral" or "otg".
17  - phys: Phandle for the PHY device
19  - phy-names: Should be "usb-phy"
21  - dmas: specifies the dma channels
23  - dma-names: specifies the names of the channels. Use "rxN" for receive
28  - vbus-supply: Phandle to a regulator providing the USB bus power.
32 - compatible: ti,da830-cppi41
33 - reg: offset and length of the following register spaces: CPPI DMA Controller,
35 - reg-names: "controller", "scheduler", "queuemgr"
36 - #dma-cells: should be set to 2. The first number represents the
39 - dma-channels: should be set to 4 representing the 4 endpoints.
40 - #dma-channels: deprecated
43 	usb_phy: usb-phy {
44 		compatible = "ti,da830-usb-phy";
45 		#phy-cells = <0>;
47 	usb0: usb@200000 {
48 		compatible = "ti,da830-musb";
51 		#address-cells = <1>;
52 		#size-cells = <1>;
54 		interrupt-names = "mc";
57 		vbus-supply = <&usb_vbus>;
59 		phy-names = "usb-phy";
65 		dma-names =
70 		cppi41dma: dma-controller@201000 {
71 			compatible = "ti,da830-cppi41";
75 			reg-names = "controller", "scheduler", "queuemgr";
77 			#dma-cells = <2>;
78 			dma-channels = <4>;