Lines Matching +full:rx +full:- +full:burst +full:- +full:length
1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/usb/chipidea,usb2-common.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Xu Yang <xu.yang_2@nxp.com>
25 clock-names:
31 power-domains:
37 reset-names:
40 "#reset-cells":
45 itc-setting:
51 ahb-burst-config:
55 used to change AHB burst configuration, check the chipidea spec for
62 tx-burst-size-dword:
64 it is vendor dependent, the tx burst size in dword (4 bytes), This
65 register represents the maximum length of a the burst in 32-bit
67 of this property will only take effect if property "ahb-burst-config"
74 rx-burst-size-dword:
76 it is vendor dependent, the rx burst size in dword (4 bytes), This
77 register represents the maximum length of a the burst in 32-bit words
79 this property will only take effect if property "ahb-burst-config"
90 should point to external connector device, which provide "USB-HOST"
93 $ref: /schemas/types.yaml#/definitions/phandle-array
96 - description: vbus extcon
97 - description: id extcon
99 phy-clkgate-delay-us:
104 non-zero-ttctrl-ttha:
126 mux-controls:
133 mux-control-names:
136 pinctrl-names:
139 In case of HSIC-mode, "idle" and "active" pin modes are mandatory.
143 - items:
144 - const: idle
145 - const: active
146 - items:
147 - const: default
148 - const: host
149 - const: device
150 - items:
151 - const: default
152 - enum:
153 - host
154 - device
155 - items:
156 - const: default
158 pinctrl-0:
161 pinctrl-1:
167 phy-names:
168 const: usb-phy
170 vbus-supply:
173 usb-phy:
181 using the OF graph bindings specified, if the "usb-role-switch"
185 reset-gpios:
189 port: [ usb-role-switch ]
190 mux-controls: [ mux-control-names ]
193 - reg
194 - interrupts
197 - $ref: usb-hcd.yaml#
198 - $ref: usb-drd.yaml#