Lines Matching +full:gpio +full:- +full:cfg

5   - compatible : "cirrus,cs42l52"
7   - reg : the I2C address of the device for I2C
11   - cirrus,reset-gpio : GPIO controller's phandle and the number
12   of the GPIO used to reset the codec.
14   - cirrus,chgfreq-divisor : Values used to set the Charge Pump Frequency.
21   - cirrus,mica-differential-cfg : boolean, If present, then the MICA input is configured
23   Single-ended input. Single-ended mode allows for MIC1 or MIC2 muxing for input.
25   - cirrus,micb-differential-cfg : boolean, If present, then the MICB input is configured
27   Single-ended input. Single-ended mode allows for MIC1 or MIC2 muxing for input.
29   - cirrus,micbias-lvl: Set the output voltage level on the MICBIAS Pin
42 	reset-gpio = <&gpio 10 0>;
43 	cirrus,chgfreq-divisor = <0x05>;
44 	cirrus.mica-differential-cfg;
45 	cirrus,micbias-lvl = <5>;