Lines Matching +full:sub +full:- +full:blocks

8 Hardware blocks typically receive a reset signal. This signal is generated by
10 reset consumer (the module being reset, or a module managing when a sub-
15 specifier - a list of DT cells that represents the reset signal within the
21 in hardware for a reset signal to affect multiple logically separate HW blocks
35 #reset-cells:	Number of cells in a reset specifier; Typically 0 for nodes
41 	rst: reset-controller {
42 		#reset-cells = <1>;
51 		#reset-cells, then only the phandle portion of the pair will
55 reset-names:	List of reset signal name strings sorted in the same order as
56 		the resets property. Consumers drivers will use reset-names to
63 		reset-names = "reset";
70 		reset-names = "i2s1", "i2s2", "dma", "mixer";
73 This represents a bus that controls the reset signal of each of four sub-