bindings/regulator/tps65090.txt

4 - compatible: "ti,tps65090"
5 - reg: I2C slave address
6 - interrupts: the interrupt outputs of the controller
7 - regulators: A node that houses a sub-node for each regulator within the
8   device. Each sub-node is identified using the node's name, with valid
9   values listed below. The content of each sub-node is defined by the
10   standard binding for regulators; see regulator.txt.
11   dcdc[1-3], fet[1-7] and ldo[1-2] respectively.
12 - vsys[1-3]-supply: The input supply for DCDC[1-3] respectively.
13 - infet[1-7]-supply: The input supply for FET[1-7] respectively.
14 - vsys-l[1-2]-supply: The input supply for LDO[1-2] respectively.
17 - ti,enable-ext-control: This is applicable for DCDC1, DCDC2 and DCDC3.
19 - dcdc-ext-control-gpios: This is applicable for DCDC1, DCDC2 and DCDC3.
21   number should be provided. If it is externally controlled and no GPIO
22   entry then driver will just configure this rails as external control
23   and will not provide any enable/disable APIs.
24 - ti,overcurrent-wait: This is applicable to FET registers, which have a
26   should be between 0 - 3.  If this property isn't present we won't touch the
29 Each regulator is defined using the standard binding for regulators.
38 		vsys1-supply = <&some_reg>;
39 		vsys2-supply = <&some_reg>;
40 		vsys3-supply = <&some_reg>;
41 		infet1-supply = <&some_reg>;
42 		infet2-supply = <&some_reg>;
43 		infet3-supply = <&some_reg>;
44 		infet4-supply = <&some_reg>;
45 		infet5-supply = <&some_reg>;
46 		infet6-supply = <&some_reg>;
47 		infet7-supply = <&some_reg>;
48 		vsys-l1-supply = <&some_reg>;
49 		vsys-l2-supply = <&some_reg>;
53 				regulator-name = "dcdc1";
54 				regulator-boot-on;
55 				regulator-always-on;
56 				ti,enable-ext-control;
57 				dcdc-ext-control-gpios = <&gpio 10 0>;
61 				regulator-name = "dcdc2";
62 				regulator-boot-on;
63 				regulator-always-on;
67 				regulator-name = "dcdc3";
68 				regulator-boot-on;
69 				regulator-always-on;
73 				regulator-name = "fet1";
74 				regulator-boot-on;
75 				regulator-always-on;
79 				regulator-name = "fet2";
80 				regulator-boot-on;
81 				regulator-always-on;
85 				regulator-name = "fet3";
86 				regulator-boot-on;
87 				regulator-always-on;
91 				regulator-name = "fet4";
92 				regulator-boot-on;
93 				regulator-always-on;
97 				regulator-name = "fet5";
98 				regulator-boot-on;
99 				regulator-always-on;
103 				regulator-name = "fet6";
104 				regulator-boot-on;
105 				regulator-always-on;
109 				regulator-name = "fet7";
110 				regulator-boot-on;
111 				regulator-always-on;
115 				regulator-name = "ldo1";
116 				regulator-boot-on;
117 				regulator-always-on;
121 				regulator-name = "ldo2";
122 				regulator-boot-on;
123 				regulator-always-on;