Lines Matching +full:feedback +full:- +full:pin

1 # SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause
3 ---
4 $id: http://devicetree.org/schemas/regulator/rohm,bd71837-regulator.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Matti Vaittinen <mazziesaccount@gmail.com>
15 Documentation/devicetree/bindings/mfd/rohm,bd71837-pmic.yaml
21 regulator-boot-on at least for BUCK6 and BUCK7 so that those are not
31 "^LDO[1-7]$":
38 regulator-name:
39 pattern: "^ldo[1-7]$"
45 "^BUCK[1-8]$":
52 regulator-name:
53 pattern: "^buck[1-8]$"
57 rohm,dvs-run-voltage:
65 rohm,dvs-idle-voltage:
73 rohm,dvs-suspend-voltage:
84 # buck | dvs-run-voltage | dvs-idle-voltage | dvs-suspend-voltage
85 # ----------------------------------------------------------------
87 # ----------------------------------------------------------------
89 # ----------------------------------------------------------------
91 # ----------------------------------------------------------------
93 # ----------------------------------------------------------------
99 # PMIC HW state machine) - then you should set this property.
102 rohm,no-regulator-enable-control:
110 # connected to feedback-pin (over suitable resistors) is getting popular
118 # |---------------|
119 # | buck 8 |-------+----->Vout
121 # |---------------| |
124 # +-------+--R2----+
128 # V FB-pull-up
132 # Vout_o = Vo - (Vpu - Vo)*R2/R1
138 # Vpu is the pull-up voltage V FB-pull-up in the picture
141 rohm,fb-pull-up-microvolt:
143 Feedback-pin has pull-up connection to adjust voltage range. This is
144 the used pull-up voltage before R1.
146 rohm,feedback-pull-up-r1-ohms:
148 Feedback-pin has pull-up connection to adjust voltage range. This is
151 rohm,feedback-pull-up-r2-ohms:
153 Feedback-pin has pull-up connection to adjust voltage range. This is
157 - regulator-name