bindings/regulator/regulator.yaml

38     description: boolean, regulator should never be disabled
46       This property is intended to only be used for regulators where
55     description: allow the regulator performance level to be configured
60       disabling ramp rate, it should be explicitly initialised to zero (regulator-ramp-delay
102       for the regulator at run-time.  Elements may be specified in any order.
128       hardware performs emergency shutdown. Zero can be passed to disable
129       protection and value '1' indicates that protection should be enabled but
130       limit setting can be omitted.
135       Zero can be passed to disable error detection and value '1' indicates
136       that detection should be enabled but limit setting can be omitted.
140       is assumed still to be functional but approaching limit where it gets
141       damaged. Recovery actions should be initiated. Zero can be passed to
143       be enabled but limit setting can be omitted.
147       hardware performs emergency shutdown. Zero can be passed to disable
148       protection and value '1' indicates that protection should be enabled but
149       limit setting can be omitted. Limit is given as microvolt offset from
155       Zero can be passed to disable error detection and value '1' indicates
156       that detection should be enabled but limit setting can be omitted. Limit
161       is assumed still to be functional but approaching limit where it gets
162       damaged. Recovery actions should be initiated. Zero can be passed to
164       be enabled but limit setting can be omitted. Limit is given as microvolt
169       hardware performs emergency shutdown. Zero can be passed to disable
170       protection and value '1' indicates that protection should be enabled but
171       limit setting can be omitted. Limit is given as microvolt offset from
177       Zero can be passed to disable error detection and value '1' indicates
178       that detection should be enabled but limit setting can be omitted. Limit
183       hardware is assumed still to be functional but approaching limit where
184       it gets damaged. Recovery actions should be initiated. Zero can be passed
186       be enabled but limit setting can be omitted. Limit is given as microvolt
195       be carried out in preparation for potential power loss.
199       hardware performs emergency shutdown. Zero can be passed to disable
200       protection and value '1' indicates that protection should be enabled but
201       limit setting can be omitted.
206       Zero can be passed to disable error detection and value '1' indicates
207       that detection should be enabled but limit setting can be omitted.
211       hardware is assumed still to be functional but approaching limit where it
212       gets damaged. Recovery actions should be initiated. Zero can be passed to
214       be enabled but limit setting can be omitted.
227       is 2-way - all coupled regulators should be linked with each other.
228       A regulator should not be coupled with its supplier.
241       that can be changed safely in a single step.
256         description: regulator should be on in suspend state.
260         description: regulator should be off in suspend state.
264         description: minimum voltage may be set in suspend state.
267         description: maximum voltage may be set in suspend state.
270         description: the default voltage which regulator would be set in
277           in suspend can be changed in runtime.