Lines Matching +full:uart2 +full:- +full:pins
4 - compatible : "sirf,prima2-pinctrl"
5 - reg : Address range of the pinctrl registers
6 - interrupts : Interrupts used by every GPIO group
7 - gpio-controller : Indicates this device is a GPIO controller
8 - interrupt-controller : Marks the device node as an interrupt controller
10 - sirf,pullups : if n-th bit of m-th bank is set, set a pullup on GPIO-n of bank m
11 - sirf,pulldowns : if n-th bit of m-th bank is set, set a pulldown on GPIO-n of bank m
13 Please refer to pinctrl-bindings.txt in this directory for details of the common
17 Each of these subnodes represents some desired configuration for a group of pins.
19 Required subnode-properties:
20 - sirf,pins : An array of strings. Each string contains the name of a group.
21 - sirf,function: A string containing the name of the function to mux to the
26 drivers/pinctrl/pinctrl-sirf.c
29 uart2_pins_a: uart2@0 {
31 sirf,pins = "uart2grp";
32 sirf,function = "uart2";
35 uart2_noflow_pins_a: uart2@1 {
37 sirf,pins = "uart2_nostreamctrlgrp";
42 For a specific board, if it wants to use uart2 without hardware flow control,
43 it can add the following to its board-specific .dts file.
44 uart2: uart@b0070000 {
45 pinctrl-names = "default";
46 pinctrl-0 = <&uart2_noflow_pins_a>;