net/wireless/brcm%2Cbcm4329-fmac.yaml

1 # SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/net/wireless/brcm,bcm4329-fmac.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10   - Arend van Spriel <arend@broadcom.com>
19   - $ref: ieee80211.yaml#
24       - items:
25           - enum:
26               - brcm,bcm43143-fmac
27               - brcm,bcm4341b0-fmac
28               - brcm,bcm4341b4-fmac
29               - brcm,bcm4341b5-fmac
30               - brcm,bcm4329-fmac
31               - brcm,bcm4330-fmac
32               - brcm,bcm4334-fmac
33               - brcm,bcm43340-fmac
34               - brcm,bcm4335-fmac
35               - brcm,bcm43362-fmac
36               - brcm,bcm4339-fmac
37               - brcm,bcm43430a0-fmac
38               - brcm,bcm43430a1-fmac
39               - brcm,bcm43455-fmac
40               - brcm,bcm43456-fmac
41               - brcm,bcm4354-fmac
42               - brcm,bcm4356-fmac
43               - brcm,bcm4359-fmac
44               - brcm,bcm4366-fmac
45               - cypress,cyw4373-fmac
46               - cypress,cyw43012-fmac
47               - infineon,cyw43439-fmac
48           - const: brcm,bcm4329-fmac
49       - enum:
50           - brcm,bcm4329-fmac
51           - pci14e4,43dc  # BCM4355
52           - pci14e4,4464  # BCM4364
53           - pci14e4,4488  # BCM4377
54           - pci14e4,4425  # BCM4378
55           - pci14e4,4433  # BCM4387
63     description: Out-of-band (OOB) IRQ line for waking up the host
67   interrupt-names:
68     description: Name for the OOB IRQ, this must be set to "host-wake".
69     const: host-wake
71   brcm,drive-strength:
77   reset-gpios:
79     description: A GPIO line connected to the WL_RST line, if present
82   brcm,ccode-map:
83     $ref: /schemas/types.yaml#/definitions/string-array
85       brcmfmac firmware country code and revision.
87       pattern: '^[A-Z][A-Z]-[A-Z][0-9A-Z]-[0-9]+$'
89   brcm,ccode-map-trivial:
91       Use a trivial mapping of ISO3166 country codes to brcmfmac firmware
92       country code and revision: cc -> { cc, 0 }. In other words, assume that
93       the CLM blob firmware uses ISO3166 country codes as well, and that all
95       brcm,ccode-map. If both properties are specified, then brcm,ccode-map
99   brcm,cal-blob:
100     $ref: /schemas/types.yaml#/definitions/uint8-array
101     description: A per-device calibration blob for the Wi-Fi radio. This
105   brcm,board-type:
110       construct firmware and NVRAM configuration filenames, allowing for
112       WiFi subsystem to share the same firmware/NVRAM files. On Apple platforms,
113       this should be the Apple module-instance codename prefixed by "apple,",
116   apple,antenna-sku:
119       on Apple platforms. This is use to build firmware filenames, to allow
120       platforms with different antenna configs to have different firmware and/or
125   - compatible
126   - reg
131   - |
132     #include <dt-bindings/interrupt-controller/irq.h>
133     #include <dt-bindings/gpio/gpio.h>
138       clock-names = "mclk", "apb_pclk";
140       bus-width = <4>;
141       non-removable;
142       vmmc-supply = <&wl_bt_reg>;
143       #address-cells = <1>;
144       #size-cells = <0>;
147         compatible = "brcm,bcm4334-fmac", "brcm,bcm4329-fmac";
149         interrupt-parent = <&gpio>;
151         interrupt-names = "host-wake";
152         reset-gpios = <&gpio 23 GPIO_ACTIVE_LOW>;
153         brcm,ccode-map = "JP-JP-78", "US-Q2-86";