bindings/net/microchip%2Cenc28j60.txt

3 This is a standalone 10 MBit ethernet controller with SPI interface.
5 For each device connected to a SPI bus, define a child node within
6 the SPI master node.
9 - compatible: Should be "microchip,enc28j60"
10 - reg: Specify the SPI chip select the ENC28J60 is wired to
11 - interrupts: Specify the interrupt index within the interrupt controller (referred
12               to above in interrupt-parent) and interrupt type. The ENC28J60 natively
15 - pinctrl-names: List of assigned state names, see pinctrl binding documentation.
16 - pinctrl-0: List of phandles to configure the GPIO pin used as interrupt line,
21 - spi-max-frequency: Maximum frequency of the SPI bus when accessing the ENC28J60.
31                 compatible = "fsl,imx28-spi";
32                 pinctrl-names = "default";
33                 pinctrl-0 = <&spi2_pins_b &spi2_sck_cfg>;
37                         pinctrl-names = "default";
38                         pinctrl-0 = <&enc28j60_pins>;
40                         interrupt-parent = <&gpio3>;
42                         spi-max-frequency = <12000000>;
49                         fsl,pinmux-ids = <
52                         fsl,drive-strength = <MXS_DRIVE_4mA>;
54                         fsl,pull-up = <MXS_PULL_DISABLE>;