bindings/mmc/ti-omap-hsmmc.txt

10 --------------------
11 - compatible:
12  Should be "ti,omap2-hsmmc", for OMAP2 controllers
13  Should be "ti,omap3-hsmmc", for OMAP3 controllers
14  Should be "ti,omap3-pre-es3-hsmmc" for OMAP3 controllers pre ES3.0
15  Should be "ti,omap4-hsmmc", for OMAP4 controllers
16  Should be "ti,am33xx-hsmmc", for AM335x controllers
17  Should be "ti,k2g-hsmmc", "ti,omap4-hsmmc" for 66AK2G controllers.
20 ---------------------------------
22 - ti,hwmods: Must be "mmc<n>", n is controller instance starting 1.
25 - power-domains:Should contain a phandle to a PM domain provider node
28 		Documentation/devicetree/bindings/soc/ti/sci-pm-domain.yaml
29 - clocks:	Must contain an entry for each entry in clock-names. Should
31 		usage in Documentation/devicetree/bindings/clock/ti,sci-clk.yaml
32 - clock-names:	Shall be "fck" for the functional clock,
37 --------------------
38 - ti,dual-volt:		boolean, supports dual voltage cards
39 - <supply-name>-supply:	phandle to the regulator device tree node
40 			  "supply-name" examples are "vmmc",
42 - ti,non-removable:	non-removable slot (like eMMC)
43 - ti,needs-special-reset:	Requires a special softreset sequence
44 - ti,needs-special-hs-handling:	HSMMC IP needs special setting
46 - dmas:			List of DMA specifiers with the controller specific
49 - dma-names:		List of DMA request names. These strings correspond
59 		compatible = "ti,omap4-hsmmc";
62 		ti,dual-volt;
63 		bus-width = <4>;
64 		vmmc-supply = <&vmmc>; /* phandle to regulator node */
65 		ti,non-removable;
71 		compatible = "ti,omap4-hsmmc";
74 		ti,dual-volt;
75 		bus-width = <4>;
76 		vmmc-supply = <&vmmc>; /* phandle to regulator node */
77 		ti,non-removable;
80 		dma-names = "tx", "rx";
88                              ------
90                               ------
94        ------                -------               -----
95       | card | -- CIRQ -->  | hsmmc | -- IRQ -->  | CPU |
96        ------                -------               -----
105 this work, we need to set the named pinctrl states "default" and "idle".
106 Prepare idle to remux dat1 as a gpio, and default to remux it back as sdio
107 dat1. The MMC driver will then toggle between idle and default state during
112 2. specify pinctrl states "default" and "idle", "sleep" is optional.
120 		compatible = "ti,am33xx-hsmmc";
122 		pinctrl-names = "default", "idle", "sleep"
123 		pinctrl-0 = <&mmc1_pins>;
124 		pinctrl-1 = <&mmc1_idle>;
125 		pinctrl-2 = <&mmc1_sleep>;
127 		interrupts-extended = <&intc 64 &gpio2 28 IRQ_TYPE_LEVEL_LOW>;
131 		pinctrl-single,pins = <