bindings/media/microchip%2Ccsi2dc.yaml

1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10   - Eugen Hristev <eugen.hristev@microchip.com>
13   CSI2DC - Camera Serial Interface 2 Demux Controller
19   clock domain towards a parallel interface that can be read by a sensor
26   is connected at the output to a sensor controller and the data pipe is
29   CSI2DC supports a single 'port' node as a sink port with either Synopsys
30   32-bit IDI interface or a parallel interface.
32   CSI2DC supports one 'port' node as source port with parallel interface.
44     const: microchip,sama7g5-csi2dc
53   clock-names:
59       by the next controller in pipeline, which usually is a sensor controller.
60       Normally this clock should be given by this sensor controller who
61       is also a clock source. This clock is named 'scck', sensor controller clock.
63       - const: pclk
64       - const: scck
69   dma-names:
77         $ref: /schemas/graph.yaml#/$defs/port-base
80           Input port node, single endpoint describing the input port.
84             $ref: video-interfaces.yaml#
89               bus-type:
93               bus-width:
97               clock-noncontinuous:
103               remote-endpoint: true
106         $ref: /schemas/graph.yaml#/$defs/port-base
109           Output port node, single endpoint describing the output port.
114             $ref: video-interfaces.yaml#
118               bus-type:
122               bus-width:
126               remote-endpoint: true
129       - port@0
130       - port@1
135   - compatible
136   - reg
137   - clocks
138   - clock-names
139   - ports
142   # Example for connecting to a parallel sensor controller block (video pipe)
144   - |
146         compatible = "microchip,sama7g5-csi2dc";
149         clock-names = "pclk", "scck";
152                #address-cells = <1>;
153                #size-cells = <0>;
157                                bus-type = <4>; /* MIPI CSI2 D-PHY */
158                                remote-endpoint = <&csi2host_out>;
165                                remote-endpoint = <&xisc_in>; /* output to sensor controller */
173   - |
174     #include <dt-bindings/dma/at91.h>
176         compatible = "microchip,sama7g5-csi2dc";
179         clock-names = "pclk", "scck";
181         dma-names = "rx";
184                #address-cells = <1>;
185                #size-cells = <0>;
189                                remote-endpoint = <&csi2host_out>;