bindings/input/ti%2Cdrv260x.yaml

1 # SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
7 title: Texas Instruments - drv260x Haptics driver family
10   - Andrew Davis <afd@ti.com>
15       - ti,drv2604
16       - ti,drv2605
17       - ti,drv2605l
22   vbat-supply:
30       (defined in include/dt-bindings/input/ti-drv260x.h)
43   library-sel:
46       These are ROM based waveforms pre-programmed into the IC.
48       (defined in include/dt-bindings/input/ti-drv260x.h)
50       DRV260X_LIB_EMPTY - Do not use a pre-programmed library
51       DRV260X_ERM_LIB_A - Pre-programmed Library
52       DRV260X_ERM_LIB_B - Pre-programmed Library
53       DRV260X_ERM_LIB_C - Pre-programmed Library
54       DRV260X_ERM_LIB_D - Pre-programmed Library
55       DRV260X_ERM_LIB_E - Pre-programmed Library
56       DRV260X_ERM_LIB_F - Pre-programmed Library
57       DRV260X_LIB_LRA - Pre-programmed LRA Library
60   enable-gpio:
64   enable-gpios:
67   vib-rated-mv:
70       The rated voltage of the actuator in millivolts.
71       If this is not set then the value will be defaulted to 3200 mV.
74   vib-overdrive-mv:
78       If this is not set then the value will be defaulted to 3200 mV.
82   - compatible
83   - reg
84   - enable-gpios
85   - mode
86   - library-sel
91   - |
92     #include <dt-bindings/gpio/gpio.h>
93     #include <dt-bindings/input/ti-drv260x.h>
96         #address-cells = <1>;
97         #size-cells = <0>;
102             vbat-supply = <&vbat>;
103             enable-gpios = <&gpio1 28 GPIO_ACTIVE_HIGH>;
105             library-sel = <DRV260X_LIB_LRA>;
106             vib-rated-mv = <3200>;
107             vib-overdrive-mv = <3200>;