bindings/input/dlg%2Cda7280.txt

4 - compatible: Should be "dlg,da7280".
10 - dlg,actuator-type: Set Actuator type. it should be one of:
15 - dlg,const-op-mode: Haptic operation mode for FF_CONSTANT.
19 - dlg,periodic-op-mode: Haptic operation mode for FF_PERIODIC.
30 - dlg,nom-microvolt: Nominal actuator voltage rating.
32 - dlg,abs-max-microvolt: Absolute actuator maximum voltage rating.
34 - dlg,imax-microamp: Actuator max current rating.
37 - dlg,impd-micro-ohms: the impedance of the actuator in micro ohms.
47 - dlg,ps-seq-id: the PS_SEQ_ID(pattern ID in waveform memory inside chip)
50 - dlg,ps-seq-loop: the PS_SEQ_LOOP, Number of times the pre-stored sequence
53 - dlg,gpiN-seq-id: the GPI(N)_SEQUENCE_ID, pattern to play
56 - dlg,gpiN-mode: the pattern mode which can select either
58 - dlg,gpiN-polarity: gpiN polarity which can be chosen among
63 - dlg,resonant-freq-hz: use in case of LRA.
67 - dlg,bemf-sens-enable: Enable for internal loop computations.
68 - dlg,freq-track-enable: Enable for resonant frequency tracking.
69 - dlg,acc-enable: Enable for active acceleration.
70 - dlg,rapid-stop-enable: Enable for rapid stop.
71 - dlg,amp-pid-enable: Enable for the amplitude PID.
72 - dlg,mem-array: Customized waveform memory(patterns) data downloaded to
82 		compatible = "dlg,da7280";
86 		dlg,actuator-type = "LRA";
87 		dlg,dlg,const-op-mode = <1>;
88 		dlg,dlg,periodic-op-mode = <1>;
89 		dlg,nom-microvolt = <2000000>;
90 		dlg,abs-max-microvolt = <2000000>;
91 		dlg,imax-microamp = <170000>;
92 		dlg,resonant-freq-hz = <180>;
93 		dlg,impd-micro-ohms = <10500000>;
94 		dlg,freq-track-enable;
95 		dlg,rapid-stop-enable;
96 		dlg,mem-array = <