Lines Matching full:thermistor

3 $id: http://devicetree.org/schemas/hwmon/ntc-thermistor.yaml#
6 title: NTC thermistor temperature sensors
19   When used in practice, a thermistor is often connected between ground, a
33      |/| Thermistor             | Measured voltage (mv)
47   The arrangements of where we measure the voltage over the thermistor are
51   If the pull-up resistance is 0 one end of the thermistor is connected to the
52   positive voltage and we get the thermistor on top of a pull-down resistor
53   and we take the measure between the thermistor and the pull-down resistor.
55   Conversely if the pull-down resistance is zero, one end of the thermistor is
56   connected to ground and we get the thermistor under the pull-up resistor
57   and we take the measure between the pull-up resistor and the thermistor.
65     pattern: "^thermistor(.*)?$"
111     description: Indicates how the thermistor is connected in series with
113       an illustration. If this flag is NOT specified, the thermistor is assumed
134     thermistor {