display/panel/panel-dsi-cm.yaml

1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/display/panel/panel-dsi-cm.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10   - Tomi Valkeinen <tomi.valkeinen@ti.com>
11   - Sebastian Reichel <sre@kernel.org>
23   - $ref: panel-common.yaml#
29       - enum:
30           - motorola,droid4-panel        # Panel from Motorola Droid4 phone
31           - nokia,himalaya               # Panel from Nokia N950 phone
32           - tpo,taal                     # Panel from OMAP4 SDP board
33       - const: panel-dsi-cm              # Generic DSI command mode panel compatible fallback
39   vddi-supply:
42       more than one power supply with panel-specific constraints governing the
44       supply is sufficient, either because the panel has a single power rail, or
45       because all its power rails can be driven by the same supply. In that case
46       the vddi-supply property specifies the supply powering the panel as a
49   vpnl-supply:
51       When the display panel needs a second power supply, this property can be
52       used in addition to vddi-supply. Both supplies will be enabled at the
55   width-mm: true
56   height-mm: true
59   panel-timing: true
61   reset-gpios: true
62   te-gpios: true
68   - compatible
69   - reg
72   - |
73     #include <dt-bindings/gpio/gpio.h>
75     dsi-controller {
76         #address-cells = <1>;
77         #size-cells = <0>;
80             compatible = "tpo,taal", "panel-dsi-cm";
82             reset-gpios = <&gpio4 6 GPIO_ACTIVE_HIGH>;