bindings/clock/baikal%2Cbt1-ccu-div.yaml

5 $id: http://devicetree.org/schemas/clock/baikal,bt1-ccu-div.yaml#
15   responsible for the chip subsystems clocking and resetting. The CCU is
19   by means of an embedded into CCU PLLs and gateable/non-gateable dividers. The
22   registers. Baikal-T1 CCU is logically divided into the next components:
24      in general can provide any frequency supported by the CCU PLLs).
32           | Baikal-T1 CCU |
50   output is primarily connected to a set of CCU PLLs. Some of PLLs CLKOUT are
51   then passed over CCU dividers to create signals required for the target clock
66   where CLKIN is the reference clock coming either from CCU PLLs or from an
77   devices, are united into a single clocks provider called System Devices CCU.
79   are called AXI-bus CCU. Both of them use the common clock bindings with no
81   in the files: 'include/dt-bindings/clock/bt1-ccu.h' and
82   'include/dt-bindings/reset/bt1-ccu.h'. Since System Devices and AXI-bus CCU
90         const: baikal,bt1-ccu-axi
96         - description: CCU SATA PLL output clock
97         - description: CCU PCIe PLL output clock
98         - description: CCU Ethernet PLL output clock
111         - description: CCU SATA PLL output clock
112         - description: CCU PCIe PLL output clock
113         - description: CCU Ethernet PLL output clock
125       - baikal,bt1-ccu-axi
126       - baikal,bt1-ccu-sys
156     #include <dt-bindings/clock/bt1-ccu.h>
159       compatible = "baikal,bt1-ccu-axi";
171     #include <dt-bindings/clock/bt1-ccu.h>
174       compatible = "baikal,bt1-ccu-sys";
189       compatible = "baikal,bt1-ccu-pll";