admin-guide/media/imx.rst

115 MIPI CSI-2 OV5640 sensor, requires the i.MX6 MIPI CSI-2 receiver. But
409 i.MX6Q SabreLite with OV5642 and OV5640
413 camera interface, and the OV5640 module with a MIPI CSI-2
425 The MIPI CSI-2 OV5640 module is connected to the i.MX internal MIPI CSI-2
428 vc2 directly to IPU2 CSI0, and vc3 to the IPU2 CSI1 mux. The OV5640 is
430 OV5640 must not share the same i2c slave address.
434 the OV5640, transmitting on MIPI CSI-2 virtual channel 1 (which is
437 OV5640 UYVY2X8:
445    # Setup links for OV5640
446    media-ctl -l "'ov5640 1-0040':0 -> 'imx6-mipi-csi2':0[1]"
453    # Configure pads for OV5640 pipeline
454    media-ctl -V "'ov5640 1-0040':0 [fmt:UYVY2X8/640x480 field:none]"
579 i.MX6Q SabreSD with MIPI CSI-2 OV5640
583 interface OV5642 module on IPU1 CSI0, and a MIPI CSI-2 OV5640
584 module. The OV5642 connects to i2c bus 1 and the OV5640 to i2c bus 2.
587 OV5642 and the MIPI CSI-2 OV5640, but as of this writing only the MIPI
588 CSI-2 OV5640 has been tested, so the OV5642 node is currently disabled.
589 The OV5640 module connects to MIPI connector J5. The NXP part number
590 for the OV5640 module that connects to the SabreSD board is H120729.
593 capture from the OV5640, transmitting on MIPI CSI-2 virtual channel 0:
598    media-ctl -l "'ov5640 1-003c':0 -> 'imx6-mipi-csi2':0[1]"
603    media-ctl -V "'ov5640 1-003c':0 [fmt:UYVY2X8/640x480]"
635 from the OV5640, transmitting on MIPI CSI-2 virtual channel 0. It also
641    media-ctl -l "'ov5640 1-003c':0 -> 'imx6-mipi-csi2':0[1]"
648    media-ctl -V "'ov5640 1-003c':0 [fmt:UYVY2X8/640x480]"