Lines Matching +full:host +full:- +full:command

13 	These commands are used to configure the host sleep parameters::
14 	bit 8:0  -- Gap
15 	bit 16:8 -- GPIO
17 	where GPIO is the pin number of GPIO used to wake up the host.
18 	It could be any valid GPIO pin# (e.g. 0-7) or 0xff (SDIO interface
22 	wakeup event, or 0xff for special host sleep setting.
26 		# Use SDIO interface to wake up the host and set GAP to 0x80:
30 		# Use GPIO pin #3 to wake up the host and set GAP to 0xff:
39 			1 	-- Enable auto sleep mode
40 			0 	-- Disable auto sleep mode
54 	These commands are used to enable host sleep or wake up firmware
58 			1	-- Enable host sleep
59 			0	-- Wake up firmware
63 		# Enable host sleep
84 	This command displays current auto sleep status.
87 	This command display the power save state.
90 	This command display the host sleep state.
93 	This command displays the value of Tx download ready flag.
95 Issuing a raw hci command
98 Use hcitool to issue raw hci command, refer to hcitool manual
104 Interface Control Command::
106 	hcitool cmd 0x3f 0x5b 0xf5 0x01 0x00    --Enable All interface
107 	hcitool cmd 0x3f 0x5b 0xf5 0x01 0x01    --Enable Wlan interface
108 	hcitool cmd 0x3f 0x5b 0xf5 0x01 0x02    --Enable BT interface
109 	hcitool cmd 0x3f 0x5b 0xf5 0x00 0x00    --Disable All interface
110 	hcitool cmd 0x3f 0x5b 0xf5 0x00 0x01    --Disable Wlan interface
111 	hcitool cmd 0x3f 0x5b 0xf5 0x00 0x02    --Disable BT interface
118 - /lib/firmware/sd8688_helper.bin
119 - /lib/firmware/sd8688.bin
124 git.infradead.org/users/dwmw2/linux-firmware.git/libertas/