Lines Matching +full:firmware +full:- +full:gpio
14 bit 8:0 -- Gap
15 bit 16:8 -- GPIO
17 where GPIO is the pin number of GPIO used to wake up the host.
18 It could be any valid GPIO pin# (e.g. 0-7) or 0xff (SDIO interface
30 # Use GPIO pin #3 to wake up the host and set GAP to 0xff:
39 1 -- Enable auto sleep mode
40 0 -- Disable auto sleep mode
54 These commands are used to enable host sleep or wake up firmware
58 1 -- Enable host sleep
59 0 -- Wake up firmware
67 # Wake up firmware
106 hcitool cmd 0x3f 0x5b 0xf5 0x01 0x00 --Enable All interface
107 hcitool cmd 0x3f 0x5b 0xf5 0x01 0x01 --Enable Wlan interface
108 hcitool cmd 0x3f 0x5b 0xf5 0x01 0x02 --Enable BT interface
109 hcitool cmd 0x3f 0x5b 0xf5 0x00 0x00 --Disable All interface
110 hcitool cmd 0x3f 0x5b 0xf5 0x00 0x01 --Disable Wlan interface
111 hcitool cmd 0x3f 0x5b 0xf5 0x00 0x02 --Disable BT interface
113 SD8688 firmware
118 - /lib/firmware/sd8688_helper.bin
119 - /lib/firmware/sd8688.bin
124 git.infradead.org/users/dwmw2/linux-firmware.git/libertas/