Lines Matching full:parallel

2 Linux and parallel port IDE devices
11 Owing to the simplicity and near universality of the parallel port interface
13 CD-ROM, LS-120 and tape drives use the parallel port to connect to their
15 to pass commands and data through the parallel port interface, most
17 a parallel-port adapter chip added in.  Some of the original parallel port
24 the device being addressed via the parallel cable is a standard SCSI
28 of external parallel port devices, however, are now based on standard
30 were to open up a parallel port CD-ROM drive, for instance, one would
32 that interconnected a standard PC parallel port cable and a standard
36 The document describes the support in Linux for parallel port IDE
37 devices.  It does not cover parallel port SCSI devices, "ditto" tape
39 parallel port IDE subsystem, including:
58 the parallel ports.
61 parallel port IDE adapter chips.  Thanks to the interest and encouragement of
89 In either case, you will need to select "Parallel port IDE device support"
90 and at least one of the parallel port communication protocols.
91 If you do not know what kind of parallel port adapter is used in your drive,
173 concern the parallel port CMOS settings.  At this time, none of the
175 If you are able to do so, please set your parallel port into EPP mode
181 Some parallel ports cannot reliably transfer data at full speed.  To
198 the parallel port.  As the reset operation is potentially disruptive in